Hi all,
I'm getting ready to do the "blue wire mod" on my fan ('07 F250 6.0) and as soon as fund allow I'm going to be adding the fuel pressure gauge to my CTS. I was planning to run the wires in some sort of wire loom. I figured I would run them together straight back to the firewall and then over to the drivers side. My question is...will standard (autozone, O'reilley's, etc.) wire loom be ok or should I find something better? Not doing this for appearance, just to keep the wires a bit safer.
Thanks,
Steve
I'm getting ready to do the "blue wire mod" on my fan ('07 F250 6.0) and as soon as fund allow I'm going to be adding the fuel pressure gauge to my CTS. I was planning to run the wires in some sort of wire loom. I figured I would run them together straight back to the firewall and then over to the drivers side. My question is...will standard (autozone, O'reilley's, etc.) wire loom be ok or should I find something better? Not doing this for appearance, just to keep the wires a bit safer.
Thanks,
Steve
