I’m recently bent my front axle in my 2011 f250 and i’m looking for a new axel dose anyone know if the 2011 6.2 had the same front axle as the 6.7 i believe mines a srw with 3.73 gears and i have found the same ones but didn’t know if it matters that there out of the 6.2?
Milesbell
Dana 60 has been used for many years the gas should not matter at all
you can always go to copart and verify
you can always go to copart and verify
Looks like you just need to verify the splines. 1999-2021
'05-'17 Ford Super 60 F250/F350 front, w/stub axle seal - Broncograveyard.com
2005-2015 Super Duty D60 passenger side inner outer and ujoint axle assembly. Genuine Spicer quality with front axle shaft assemblies. What sets genuine Spicer front axle assemblies apart from the knockoffs? Application specific design and engineering, quality materials, precision...
shop.broncograveyard.com
Yep, got to be sure of the gears that are installed in a yard pulled axle. Otherwise post pics of the bent axle....that's pretty hard core.
Take the VIN and run it on a Ford truck site. They should be able to give you a complete readout on every aspect of your truck. I don't remember the site I used, (I think it was FordF150.net, but I found it in about 30 minutes online). I got a complete printout, (all spec's from the factory on my truck's build), on my 2008 F350 DRW,,, for free...!!!
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
