OK guys, I'm having some 4WD issues. When I turn the selector I instantly get the "check 4x4 light" and of course, no 4wd. The locking diff works so I don't think it's the selector itself.
I'm just curious as to what the voltage to the 2 pin Tcase motor should be? When I checked it yesterday it was reading 5.3 Volts. When I checked the 6 pin connection it was getting around 11.8 volts.
Any thoughts? Also, when I unplugged the 6 pin connector the 4x4 low light came on and the hubs locked in?? guessing one of those pins is normally open and when I unplugged it it closed and locked the hubs.
thanks
Mike
I'm just curious as to what the voltage to the 2 pin Tcase motor should be? When I checked it yesterday it was reading 5.3 Volts. When I checked the 6 pin connection it was getting around 11.8 volts.
Any thoughts? Also, when I unplugged the 6 pin connector the 4x4 low light came on and the hubs locked in?? guessing one of those pins is normally open and when I unplugged it it closed and locked the hubs.
thanks
Mike
