Ford Powerstroke Diesel Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
215 Posts
Discussion Starter #1
I am currently in the middle of a E4OD to a C6 swap in my project. I noticed that the T/C will not fully engage in the flexplate b/c the pilot area is bottoming out in the crankshaft, SO. I am in need of the flexplate spacer used in the 7.3 IDI engines that were backed with the C6. I would also like to buy the reinforcement ring and bolts if you have them. Just shoot me a PM and I would like to see a pic to make sure its what I am looking for. Thanks
 

·
Registered
Joined
·
215 Posts
Discussion Starter #2
ttt, still need this. I can do with just the thick spacer right now. Thanks
 
1 - 2 of 2 Posts
Top