Ford Powerstroke Diesel Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
2,391 Posts
I usually run about 30% meth, but for the washer fluid depending on the freezing temp is how much meth it has it think. here is the ratio.

+20 - 7% methanol

0 - 23% methanol

-10 - 28% methanol

-20 - 35% methanol

-25 - 38% methanol

-50 - 62% methanol
 

·
Registered
Joined
·
2,391 Posts
It might be putting too much, mine puts 15% injection at 15 pounds of boost.
 

·
Registered
Joined
·
2,391 Posts
ok i ran my 40 meth 60 water and i got white smoke and felt like it was missing!!!! So i disconnected the ground so it wont turn on, The trucks ok but why did this happen?

The mix wasnt what i thought it was maybe?

It turnes by a boost switch at 10ish psi
I think it is injecting too early. It should be around 20 psi when there is alot of air flow. If I understand what you are saying once you hit 10 psi it comes on at 100% injection. I am assuming you dont have a progressive controller. It shouldnt be injecting too much because i am running two 625ml nozzles.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top