Ford Powerstroke Diesel Forum banner
1 - 1 of 1 Posts

·
Premium Member
Joined
·
3,709 Posts
Just a tip from my ramblings below. My TFT sensor went out back in August. I only had the P0713 code though...

For the little "ramp" I mentioned, here's a visual I found on another site:

About HERE is where it should pop out with tons of fluid for your brain cavity :D LOL

-jokester

Well, got the TFT sensor replaced and the trans fluid/filters changed out.

To anyone reading this and having to change that sensor. I've read where people said to rotate the sensor 90° counter clockwise, then pull the sensor to get it out because of it's "T" shaped end. You don't rotate it that much. You only have to rotate it ~45° counter clockwise and then the sensor will free up. You'll know when it's ready to come out when the little tang on the sensor (the tang that locks into place in the divet during installation) clears the "ramp" (I should have taken a pic, but didn't...). And I used the same small screwdriver to lift up on that tang to unlock the sensor so I could start to turn it that I used to unlock the harness connector from the sensor.

Anywho...FYI about stuff I learned in the last few hours LOL 😆

-jokester
 
  • Like
Reactions: bismic
1 - 1 of 1 Posts
Top