Ford Powerstroke Diesel Forum banner

Small suspension lift kit

986 Views 5 Replies 2 Participants Last post by  HeavyAssault
Hey all.

Does anybody know of a company that makes a 1" or 1.5" suspension block spacer for the FRONT and REAR for the 2016 F-250?

I know they make these in fronts for "leveling kits" but I don't know about everyone else's truck but my stock F-250 Plat sits nearly perfectly level right from the factory. Taking a tape measure the difference is about only 1/3" higher in the back than the front.

But I want to lift the truck a tiny bit and go with 1" larger tires.
I can't seem to find a company that makes a suspension block for the front and the rear that lifts it 1" to 1.5"

Suggestions?

Thanks
1 - 3 of 6 Posts
OneUpOffroad makes an adjustable kit for the front. From 0-2.5" so you can dial it in to your liking. Buy some F350 rear blocks, they are about 1.5" (give or take) over your F250 blocks. Since the OUO front is adjustable you can put in the rear blocks then adjust the front.
  • Like
Reactions: 1
I'd suggest finding a set. Dealer cost could be a tad high. People sell them here in the Classifieds, or on Craigslist. Might use the dealership for the new U-bolts. I'd have to see if I have a set.
  • Like
Reactions: 1
I'd use a VIN from a F350 of your year. The dealer will have the correct part numbers.
  • Like
Reactions: 1
1 - 3 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top