Ford Powerstroke Diesel Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
87 Posts
Discussion Starter #1
I put my motor back together over the weekend I deleted the egr system completely with an elite diesel egr delete kit and intake elbow I reprogrammed the truck to stock then programmed it back to a rcd 450hp tune going through the prompts on the sct device 8900 I hit yes to the air intake and yes to the dpf delete and yes on the disabled the egr but it keeps poping up a code that wrench code on the dash because it does not see the egr could this be a issue with the programmer not downloading the parameters into the ecm? or is there another problem any ideas are welcome?
 
1 - 1 of 1 Posts
Top