Ford Powerstroke Diesel Forum banner
1 - 11 of 11 Posts

·
Registered
Joined
·
316 Posts
Discussion Starter · #1 ·
How do I get rid of this code I have an SCT XCAL3 and it throws this stupid code every day very annoying how do I make it stop?
 

·
PMR = JUNK
Joined
·
11,272 Posts
Get a bigger HPO system or back out of the throttle.
 

·
Registered
Joined
·
392 Posts
you could have an IPR o ring or injector O ring issue. when the o rings start to fail you will get a p1211 code alot easier, then at some point will run into hot start issues.
 

·
Registered
Joined
·
316 Posts
Discussion Starter · #4 ·
Any recommendations on the HPOP?
 

·
Registered
Joined
·
316 Posts
Discussion Starter · #6 ·
well the injectors have less than 100K on them and my other 7.3 did same thing when turned up with even lower mileage, how hard is it to replace the orings?? and wat kind of HPOP would yall recommend
 

·
Powerstroke Junkie
Joined
·
8,307 Posts
The adrenaline HPOP from Dieselsite.com will stop it. It will be my next mod.

NCH
 

·
Registered
Joined
·
862 Posts
IMO get ya something like a scanguage or AE and run some test 1st. It could just be the tuning you are using is not the best.

But if it turns out the HPOP is weak then the Adrenaline from Dieselsite seems to look like a winner and will be going on my truck when the stock pump im running goes out.
 

·
Registered
Joined
·
316 Posts
Discussion Starter · #9 ·
How do I check to see if it is weak or not,
 

·
Registered
Joined
·
862 Posts
with a scan tool you can look at IPR duty cycle and ICP
What he said. Scan Tool or AE or something.

want to look at IPR Duty Cycle and IPC
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top