Ford Powerstroke Diesel Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
59 Posts
Discussion Starter · #1 ·
Good Evening


I decided this weekend I would freshen up the front suspension with new ball joints, tie rod ends et al.. I was able to get the snap ring out of the hub, but I can't seem to get it back in. Does anyone that has messed with this have any ideas?


TIA

Mike
 

·
Registered
Joined
·
59 Posts
Discussion Starter · #6 ·
I did find an article that suggested the gearwrench X snap ring pliers. I guess they put out a lot of force with that design. But there is a grainger just down the road so the knipex ones may do just as well.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top