Ford Powerstroke Diesel Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
65 Posts
Discussion Starter · #1 ·
Hey guys tried to search and around and fine my answer and didn't find what I was looking for. Doing the ball joints on my truck and I want to replace the inner outer and knuckle seals. I'm basically asking what do I need to know about removing the carrier on the truck. Its a 2008 job 1 350 dually with 4.10's. Basically I want to know if I can take this bad boy out without having to redo the backlash and what that spec is. Thanks for the help guys redirect me if this post is out of place in the forum.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top