Ford Powerstroke Diesel Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
64 Posts
Discussion Starter · #1 ·
im getting a lot of blow by some im thinking of building a engine....


i heard total rebuilds are like 1300 bucks.Would it be cheaper to just get some nice rods and pistons for the price? I need to know where to get them because i have no clue. Also a good place to get studs

I was going to do:

DIY stage 2's
D66
17* HPOP
Electric fuel
studs
rods and pistons
 

·
Registered
Joined
·
4,056 Posts
Need to find out what is causing the blow by.
Absolutely correct. If your cylinders are damaged for some reason it's going to be more than just piston(s)/rings.
Time for a C-C-C-Cummins! lol!
 

·
Registered
Joined
·
64 Posts
Discussion Starter · #4 ·
im not using the engine i have now...im buying an engine and redoing the block and stuff....i just need to know where to get rods and pistons
 

·
duct tape & zip ties
Joined
·
10,759 Posts
Absolutely correct. If your cylinders are damaged for some reason it's going to be more than just piston(s)/rings.
Time for a C-C-C-Cummins! lol!
That is what I would do. The Conversion when my 7.3L goes that is exactly what is going under my hood.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top