Ford Powerstroke Diesel Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
124 Posts
Discussion Starter #1
Have kind of a strange question, are there any unused hole or plugs in a 2005 6.0 that I can screw a water temp sending unit into. Before you all say it I know I should spend the money on a unit that will plug into my harnes but money is real tight and I have a good after market guage, and figure it would be better than nothing. I looked around briefly and it hard to see anything so I thought I would ask the experts. THANKS
 

·
Premium Member
Joined
·
20,293 Posts
The easiest way would be to remove a block drain plug, and adapt your gauge fitting to that. Or get a ScanGauge II for $170 and use the sensor that's already there :thumb:
 

·
Registered
Joined
·
124 Posts
Discussion Starter #3
thanks for the reply, yea I know the scan guage is a lot easier but can you tell me where the drain plug would be I am assuming on the lower half of the engine down around the mounts.
 

·
Premium Member
Joined
·
20,293 Posts
1 - 4 of 4 Posts
Top