Ford Powerstroke Diesel Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
30 Posts
X2 for the Craftsman unit. i had the same issue went though 3-4 pairs and ended up over at sears and the sears pliers are a good long term tool.

I would say they are about 10% too small for the big snap ring on the ball joint though. When you fully open the snap ring on the lower ball joint it barely goes on you have to tap it just a little bit to get it on so i keep a small flat head screwdriver and a little hammer in the same bag and it has never let me down. The tips are decent as well, i bent one mis using them as a pry bar but on the snap rings they work perfect.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top