Finally got my stacks!! ~ PICS~

11521 Views 179 Replies 34 Participants Last post by TwinTurboStroker, Jan 13, 2009

Clay Henry

Discussion Starter · Jan 5, 2009 (Edited)

Perfection if i do say so myself.......
This bed kit is far and above anything you can buy IMO. I think i will start making these to sell.
Under the truck the 4" nipple down goes to a short piece (8") of flex pipe, then a hard pipe 90* bend to the straight piece running to the engine. Worked out very nice other than i had to widen out the hole in the bed (that pissed me off) because we mis measured something and to center the stax, we had to widen the hole to move it over 1/4"

Comments?

See less See more

Save

1 - 1 of 180 Posts

03ccf350

· #18 · Jan 5, 2009

you know, i was never really a fan of stacks, but i like those. like was said, right height, size, and all that it looks real good CH. i have a cap but i would consider something like that.

maybe i could get them through the cap?? that would not look to dorky at all would it? :hehe:
clarence

Save

1 - 1 of 180 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month