[Taz7083]

I installed my brand new Edge CTS, went to crank her up and nothing.. lights came on.. but when I turned the key.. nothing.. Battery looks good (12.5v), FICM (48v), and I'm not getting any codes.. Anybody have any ideas?

 

[ZMANN]

I can't fathom how the CTS would do anything?

you do have the cts power up ,, correct? so that rules out the obd power

you try unhooking it yet?

 

[Taz7083]

I hooked it up to the port under the stearing wheel. The ICP voltage is reading .2v.. Is this too low to run the FICM?

 

[Hightech23435]

Try useing a hammer and hiting your starter. If it is not turning over that is where i would start. If your bat. Are at 12.5v


Sent from my iPhone where spell check hates me.

 

[Taz7083]

starter tested bad, so I replaced it.. still not getting anything when the key turns.. ICP Sensor? it's reading .2v. I was told that the FICM will not kick on if the pressure is too low...

Now I just have to find the damn thing.

 

[Dave]

Is this an insight CTS or a tuner?

An insight CTS has not effect on tuning.

Your problem is the .2V ICP reading.