Ford Powerstroke Diesel Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
154 Posts
Discussion Starter #1 (Edited)
I swapped my tranny and have the E40D, wireharness, Computer module, shifter lever. Looking to make a few bucks back that i burnt doing my swap. Also might be gettn rid of my 4.10 single rear axle.

trans (shifts rought 1st to 2nd) - $150
wireharness - $20
computer (good) - $80 SOLD!!
 

·
Registered
Joined
·
154 Posts
Discussion Starter #3
I put it on ebay with all info. Check it out then txt me 626 262-1144.
 

·
Electrical Ogre
Joined
·
12,276 Posts
Do you still have the flexplate crank spacer, or did you toss it?
 

·
Registered
Joined
·
154 Posts
Discussion Starter #5
Sorry man... i had to reuse the spacer since i lost the manual trans one, used up the auto one with a little modification.
 

·
Banned
Joined
·
1,077 Posts
I swapped my tranny and have the E40D, wireharness, Computer module, shifter lever. Looking to make a few bucks back that i burnt doing my swap. Also might be gettn rid of my 4.10 single rear axle.

trans (shifts rought 1st to 2nd) - $150
wireharness - $20
computer (good) - $80 SOLD!!
sun of a gun!!! i dont even have twenty bucks!!! i despretly need that harness man!! if no one buys it then ill take it..i cant even come up with 20$ right now...sad i know:dunno:
 

·
Registered
Joined
·
154 Posts
Discussion Starter #8 (Edited)
trans ... yes i still have it (its at a buddies house and can have it hear in fontana on sunday if u get back to me this wkend)

wiring harness... u can have it (just have to wait a lil.. send me ur address i will try n ship it to u by next week)

i work out of state and out for a week at a time.
 
1 - 8 of 8 Posts
Top