Ford Powerstroke Diesel Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 280 Results
  1. 6.0L Problems Forum
    Okay, so I have two problems here. I will explain one that led me into finding the other. At this point, neither are resolved. Problem 1: I have a vibration, driveline it would seem, between 65-70mph. I’ve replaced all u joints and CSB in the last month. I have also greased the slip joint in...
  2. 6.7 Motor Problems (2017-2019)
    “Def fault”came up on the dash and check engine light came on. Exhaust fluid is full and was full. Code is saying knock sensor. Open the hood and oil seems to be coming from hot side to inner cool . Anyone have a problem like this? Thanks!
  3. 6.0L Problems Forum
    This is a bit of a read, but I appreciate any help and guidance I receive. Recently my truck began having a sporadic issue. It goes to total power loss (like key turned off), backfiring, lots of white smoke, bucking, etc. It only happens at normal operating temperature and in the 2000 rpm range...
  4. 6.0L Problems Forum
    Last week I installed a new turbo wheel and did the 360 thrust bearing and rebuild from KC turbo. After but the truck back together on start up it blows white smoke. Had no issue like this before rebuilding the turbo. Truck sat for a week when doing the rebuild due to work.
  5. 6.0L Problems Forum
    (truck details at bottom) I have an excursion that was running great, AC compressor went out and i replaced everything but the AC lines in that system. after getting it back from recharge i was driving home when i stopped at a red light, when it turned green i had no power and a cloud of black...
  6. Parting Out
    2010 F250 King Ranch crew 6.4PSD. I had the infamous piston crack. #8. Shut down right away and everything else checks out. Truck has 158k on it and I'm parting out everything from under the hood, transmission and transfer case. No flare or slip in transmission. Still has EGR. Turbos in great...
    $1 USD
  7. 6.0L Problems Forum
    I have an 05 F250, deleted and tuned. Have had a few issues with it shuddering similar to an injector issue I had a couple years ago. Didn't replace all the injectors and just figured that was coming back to bite me. Couple weeks ago on the high way it started shuddering and I happened to notice...
  8. General 6.0L Discussion
    I was driving home today on the highway and all of a sudden my turbo started to go weak. Luckily a rest area was right around the corner so I pulled in and shut the truck off for a few minutes and started driving again and everything went back to normal. Any idea what could be the issue? 2005...
  9. 6.0L Problems Forum
    I blew my old turbo and replaced with a oem one and now it sounds like the turbo veins are coming out of the turbo under the hood and can hear them loudly at idle and it is constant. Do I just have a clamp not aligned correctly or is something else wrong
  10. 6.7 Motor Problems (2011-2016)
    I have search and read as much as I could with no luck. I am hopefully someone can share some wisdom. I have a 2012 f-250 6.7 with 215k miles. Waste gate solenoid was replaced at 205k and the turbo was replaced at 207k. The truck has all the “turbo surge” symptoms. Turbo surges bad enough...
  11. 6.0L Problems Forum
    I noticed that my CAC tube connector was really oil soaked as well as the pcv hose going to the intake pipe. I was thinking I had an oil leak in the turbo so I took everything off and cleaned up the oil as best I could. Sprayed brake cleaner into the turbo till it came out clean and dried...
  12. 6.0L Problems Forum
    2006 6.0 not bulletproofed or tuned. Hello, I am having a problem with losing boost. I get at least a po299 low boost. I have also received a P0471. It happens after the truck gets up to temp. When codes cleared it boosts well in park and neutral until it warms up completely. I have searched...
  13. General 6.7 Discussion (2011-2016)
    I'm having the squealing PROBLEM ... 327k mile 6.7 😡😡😡 New: turbo (2nd one in last year - warranty), belt, alternators (yes dual alternator setup), exhaust manifolds and up pipes (1 yr old)... Got it out of the shop Friday but it's going right back in Monday 😡😡😡 What in the world could it...
  14. 6.7 Problems Forum (2011-2016)
    Hello, I have a 2015 6.7 powerstroke with the following mods: fully deleted and tuned 5” turbo back exhaust / MPD piping kit / no limit inner cooler / KC stage 2 whistler turbo / MPD CCV reroute with internal baffle / SPE disaster prevention kit. Im getting white/blue smoke that seems to only...
  15. 6.0L Problems Forum
    I am fighting an issue with my Boost and MAP readings (on my CTS3) going erratic under high boost conditions. When under hard acceleration (>15psi boost) the readings for boost can jump to a negative number and MAP will go to 0. Usually bouncing around until I back off the throttle. This is...
  16. 6.0L Problems Forum
    My 05 6.0 with 182,400 miles started using oil and blowing white smoke out the fill tube between the last shop visit (August 5, 2021, 179,256 miles) and now. Having taken it to a couple of shops and gotten no useful advice except "throw money at it," I'm trying to see if there is any chance...
  17. 6.0L Performance Parts Discussion
    Looking to see if anyone has upgraded or changed to this? Doesn't seem unreasonable that it could be better than a stock solenoid? Would be curious to see what Charlie at KC Turbos has to say? If anyone could tag him that would be great. I have a KC 1.5 and would think about it if it wasn't a...
  18. 94-98 7.3L General Powerstroke Discussion
    I decided to look at the map for my 1996 F350 7.3L Powerstroke and it doesn't make sense. Even at full tilt my math shows the turbo barely spinning and not doing much. I had the same conclusion for the 1993 7.3 IDI turbo, the 2001 Silverado Duramax, and the 2001 Dodge Cummins. What am I doing...
  19. 6.0 Motor problems
    Ok so I've had this issue since I bought the truck and I'm at a loss as to what the problem is. The truck (2007 F250 6.0 Powerstroke) has only ever built around 8-10 PSI of boost (maximum), which is obviously low as every other 6.0 I have driven is capable of surpassing 25 PSI like it's nothing...
  20. 6.7 Problems Forum (2011-2016)
    Kind of strange if I let my truck idle for like 5 minutes and then go to drive it, the turbo won’t work. I then shut the truck off and turn it back on and it works fine. Any ideas? Happens with tow haul mode on aswell. Thanks
1-20 of 280 Results
Top