Ford Powerstroke Diesel Forum banner

transmission help

  1. 94-98 7.3L General Powerstroke Discussion
    So the transmission in my 97 7.3 F250 was having trouble shifting into over drive and was holding gears too long. I took it to the transmission shop and they rebuilt my trans and replaced all the worn out parts. I got it back when they were done and it seemed they had done nothing to it. I took...
  2. 99-03 7.3L General Discussion
    Hi y'all, I have a 2001 F-250 4x4 SuperCrew with the 7.3L PowerStroke and auto transmission, which I have owned for about three months now. This is my first SuperDuty, so I'm really new to the game. I'm reading through old threads, and will continue to do so, but have a question that I need...
  3. 6.4 Tranny Problems
    2008 6.4 5R110W trans. 111000 miles. Lately I have noticed that everytime I go to slow down the truck goes to an idle like it does not downshift and it is as if I was coasting in neutral. No codes. Nothing flashing on dash. It seems to go well while driving except it felt like a slip when I...
  4. Powerstroke.org Builds & Projects
    Ok guys need help I just had my trans rebuilt... Went with a triple disc converter by dayco and high performance clutches, up graded sprag, new balance body, new pump, new fimble switch, and new solenoids in ca valve body plus a lot of other upgrades basically the unit is been completely went...
  5. General 6.0L Discussion
    So I just bought a 2004 6.0 bulletproofed and all that and today i was messing around with the Edge Attitude CTS that it came with. I put it in level 5 "extreme" and it floored it. It made a loud banging sound though 2nd and 3rd gear and i let off because I didn't know if it just blew up or...
  6. 99-03 7.3 Transmission Problems
    Looking for some opinions to narrow down the culprit. My 2001 F350 7.3 with 4r100 has had shifting issues since I purchased it 2 years ago. I have the EDGE extreme programmer and when purchased it was on the Tow/1 setting so I didn't notice any issues when test driving. Shortly after purchasing...
  7. 99-03 7.3 Transmission Problems
    I am trying to separate my tranny from the engine so I can replace my clutch. I have removed all the bolts, transfer, electrical wire, breather hose, and the starter. I have been able to get the tranny back to where the flywheel is flush with the bell housing but no teeth are showing outside...
Top