Ford Powerstroke Diesel Forum banner
rocker arm
1-10 of 10 Results
  1. Tennessee Members
    Iv got a 95 f350 I Broke an exhaust valve rocker arm.... i have an extra intake rocker can i flip it around and make it work?
  2. General 6.0L Discussion
    I have a 06 6.0 with 280K. It started stuttering randomly at any speed. No error but I found a valve bridge on #4 exasuhs was off. So I would like to do push rods, rocker arms, the clips, and the valve bridges. However I can't find a kit for this that's not performance and expensive as s---. I...
  3. CNC Fabrication, LLC
    We are excited to announce that we are a full warehouse distributor for Manton Pushrods. In stock are Series-5 .095 and .120 wall 7.3 and 6.0 pushrods, along with lifters. Also available are rocker bridges for 6.0 and 6.4 engines as well. Powerstroke Diesel Performance: CNC Fabrication LLC...
  4. General 6.4L Discussion
    Is there anything that can be done to prevent the abnormal wearing out of the rocker arms on the 6.4? If this is such a problem on 6.4's why won't :ford: recognize this?
  5. 6.0 Motor problems
    Following a head gasket replacement and full re-assembly, firing it up and running it for a bit I busted a pushrod on my #5. I pulled it apart just enough to get the passenger valve cover off, pulled the first head bolt/rocker arm assembly on #5 off and pushrod was fine, pulled the second head...
  6. 6.4 Motor Problems
    Have a 2010 6.4L, EGR/DPF deleted, exhaust, tuner, couple other things. Couple weeks ago the idle started going funky and revving a bit, non-rhythmically. I cold start her a couple days ago and a loud popping noise shows up out of no where. The noise quiets down with some throttle, & with...
  7. Engine 911
    Have a 2010 6.4L, EGR/DPF deleted, exhaust, tuner, couple other things. Couple weeks ago the idle started going funky and revving a bit, non-rhythmically. I cold start her a couple days ago and a loud popping noise shows up out of no where. The noise quiets down with some throttle, & with...
  8. 6.0L Problems Forum
    Hi all. I'm about to dig into my passenger side #5 of my 2003 to look for push-rod/rocker problems that I believe has led to losing compression through the intake following HG repair. Once I do loosen that head stud, assuming I do find the issue and don't have to pull the head, my preference...
  9. 6.0 Motor problems
    #1) When I took the injectors out I didn't notice copper washers and since I got the heads back they don't have any in the head. Did I miss something? Maybe I mean the o-ring kit?? I'm confused 2)the plastic pieces (W302193)for the rocker arms, do I need to replace mine. Mine look fine and...
  10. 94-98 7.3L General Powerstroke Discussion
    I am in need of 4 Intake Rocker Arm assemblies and am being told by Ford dealers that they are on back order. Wondered if anyone else knows of alternative source or perhaps has more information about how long it might take ford and their sources to get their supply moving again ? Thanks...
1-10 of 10 Results
Top