Ford Powerstroke Diesel Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-11 of 11 Results
  1. 6.0 Repair Help
    I have made a post about about this before, but never had the video until now. When cold starting regardless if it’s hot or cold outside my 2005 6.0 stumbles when starting as well as takes a little longer to crank. Batteries were just replaced, ficm says 49-48.5. Truck runs great and starts time...
  2. 6.0L Problems Forum
    Hello! My name is Charles and I just wanted to get an opinion and or any advice on my 6.0 Powerstroke I have a 2004 F350 DRW quad cab with the 6.0 under the hood I bought this truck for $5000 and it drove great for 2 years, but about a year ago my rocker arm fell off the seat and I suspect it’s...
  3. General 6.0L Discussion
    I've been looking online for a DIY manual, the only one I've found is the Chilton's DIY - which doesn't seem to work in several browsers between Mac and Windows OSes. Does anyone know of any online or paper/downloadable repair manuals that cover Ford diesels? I have a 2006 Ford F-350 6.0L 4D...
  4. 6.0L Exterior Discussion
    My truck has a tiny bit of clear coat failure at the top of the passenger side fender near the front. I am not looking for a flawless repair, but to "stop the bleeding" so to speak. Does anyone have any suggestions?
  5. 6.0L Problems Forum
    Hello all, I have a 2004 Ford F350 Dually with the 6.0 poweretroke and It seems to either have broken a lifter or an exhaust valve. I currently do not have to money to fix it but I am saving up to get it repaired. I have heard that if it is a lifter that I should replace them all and if Im...
  6. 6.0 Repair Help
    My truck had a no start low oil pressure problem. I pulled the oil filter cap did some testing. Was not getting oil into filter housing. Which led me to believe low pressure oil pump. Praying I didn’t throw a lifter I pulled the front of the engine apart. Low and behold there was a little metal...
  7. General 6.0L Discussion
    Hey all! I'm looking into sending out my FICM this spring to get fixed. I've heard a lot of good about Circuit Board Medics but also came across SIA Electronics and another repair company ( I cant find again now) through just searching FICM repairs. Looking for the whole take out, mail in...
  8. 6.0 Motor problems
    Ive read many forums from this website but just recently signed up due to an ongoing problem with my 2005 6.0 that I cant seem to get any information on. For the past year or so my truck has been getting fuel in the oil to the point where it dilutes the oil so bad that it cannot build enough...
  9. 6.0 Motor problems
    Hey guys, I am seeking advice for a Ford 6.0L diesel repair shop in New Hamshire or northern mass. I am looking to get my truck bullet proofed (heads, studs, egr delete) Any advice would help. Brian
  10. 6.4 Motor Problems
    The thread in question is for the hole on the end of the head. It is where the 'banjo' bolt and line goes into the head. I was wondering what thread size it is so I can buy a tap and run it down the hole. Can anyone tell me exactly what this hole is for? My understanding is that it is a return...
  11. 99-03 7.3L Powerstroke Problems
    I bought a '02 f250 with 238k miles a few weeks back. Started good when looking at it. Drove it home about 3 hours and the next day it didn't want to start. I have driven it once since bringing it home. Oh yeh, this is my first diesel, but I have been wrenching on gassers for over 20 years. Just...
1-11 of 11 Results
Top