Search Results for ‘push rod’

Last night I installed one of those heim joints onto my clutch master cylinder push rod hoping it will solve the synchronization issues. Now when I push the clutch to the floor, the heim joint body hits the little safety switch mounted onto the rod. Has anyone experienced this before? Is there...

We are excited to announce that we are a full warehouse distributor for Manton Pushrods. In stock are Series-5 .095 and .120 wall 7.3 and 6.0 pushrods, along with lifters. Also available are rocker bridges for 6.0 and 6.4 engines as well. Powerstroke Diesel Performance: CNC Fabrication LLC...

HOW does one go about this - Working on a 2001 F350 and can not get the clutch push rod detached from the master cylinder. NVM: got a phone call with the answer - job complete.

Following a head gasket replacement and full re-assembly, firing it up and running it for a bit I busted a pushrod on my #5. I pulled it apart just enough to get the passenger valve cover off, pulled the first head bolt/rocker arm assembly on #5 off and pushrod was fine, pulled the second head...

Have a 2010 6.4L, EGR/DPF deleted, exhaust, tuner, couple other things. Couple weeks ago the idle started going funky and revving a bit, non-rhythmically. I cold start her a couple days ago and a loud popping noise shows up out of no where. The noise quiets down with some throttle, & with...

Have a 2010 6.4L, EGR/DPF deleted, exhaust, tuner, couple other things. Couple weeks ago the idle started going funky and revving a bit, non-rhythmically. I cold start her a couple days ago and a loud popping noise shows up out of no where. The noise quiets down with some throttle, & with...

Hi all. I'm about to dig into my passenger side #5 of my 2003 to look for push-rod/rocker problems that I believe has led to losing compression through the intake following HG repair. Once I do loosen that head stud, assuming I do find the issue and don't have to pull the head, my preference...

I took my 2004 F350 in for service, and long story short, I had to replace two warped cylinder heads. I ordered "new" remaned heads from a company that will for now remain nameless, and after the Ford dealership installed them, two push rods were bent and the rocker arm cracked. My problem is...

Hi all, Well I took off the drivers side valve cover and noticed that the pushrod/rocker on the right side of one of the Injectors were not mated. The rod had moved to the left and the rocker was to the right. I can push the rod back under the rocker however the entire assembly appears to have...

I recently installed the 6.0 solutions kit from MKM customs on my 05 super duty. New head gaskets, head studs, egr delete, and oil cooler. i got it all back together n started it, it ran fine for about 10 minutes, and then i started hearing almost a loping sound from the exhaust, over the turbo...