Search Results for ‘psd’

I have a 95 7.3 psd 5 speed with 250,000 and it is doing a thing where when warm it will start and cut off like you shut the key off when holding the throttle because it won’t idle or start without holding the throttle any ideas I’m lost here this is intermittent but has gotten worse I have a...

I have a 1995 7.3 psd with a 5 speed and I have a problem where sometimes it will stall out and not start unless I hold it above idle other than that it will die. Sometimes it lopes and the CEL will come on when I start it for about a minute and when it’s on it has zero power. When going 60 and...

I purchased an Edge CTS3 monitor for my 2002 F-250 PSD a month ago. After replacing my CTS monitor when the touch screen went bad with the new upgraded??? CTS3 monitor I couldn't get it to work. It kept freezing up and would turn itself on when the key was off and out of the truck. It wouldn't...

Replaced MAP, ICP, EBP, CSP, IDM, under valve cover wiring harness and still no start. Any suggestions?? Please help

Hey guys just wanna start of with a thank you in advance for reading this If anybody can answer my questions I’d appreciate it. To start i am taking my 2005 f250 superduty to get head studded. I’m doing ucf heads with hi rev springs. I wanted to add injectors and a turbo. For the turbo I am...

I've been trying to read through some forums about this issue but i am still not sure what to do. I have a 1994 7.3 PSD. My truck the last few days has been taking forever to start with alot of sputtering, now it wont sputter at all with no smoke coming from the tail pipe and wont start. I...

I'm sure this has been tried and tried again and I know some have had varying levels of success, so we figured (step-son and I) that we can give it a shot since have some knowledge and some tools available to us. I'll try to document out how this goes as much as possible. I traded my 2011 6.7...

Howdy all, My 97 PSD has the Banks PowerPack system (intercooled), which I understand there is a different turbine housing (Banks quickspool housing?), but the compressor wheel is still stock, as far as I could find in my research.... (Bought truck with the system already on it, 14 yrs...

I purchased a '96 F350 5-speed late May. Has about 193,XXX miles on it; drove it for about two weeks and then it cut off on me and I have not been able to get it cranked since. I have racked my brain about what that cause of the issue would be and I figured a fuel problem, so I purchased a new...

**if not allowed here please remove or change location :) ** Hey there , I've sold my old lil ranger and want to make quite the improvement up to a PSD. Quick run down about me 20yr old from Canada, don't need a big truck but want one ... of course i do. If I had the money id buy a 6.7 Platinum...

I own an 01' PSD and have been having issues with the drivers rear calliper. I have replaced it a total of 3 time over the last 2 years and I need to replace it again now. The callipers are seizing and i'm not sure why. I have replace the pads and rotor as well as the brake hose. Could it be a...

Hello I'm looking to buy a 95-97 f350 or f250 with the 7.3 psd. Here's some things it must be: Single cab 7.3 psd 4x4 No major rot/rust Not looking for a project, minor repairs aren't a big deal but it has to be able to be driven upon purchase. Preferably 5speed but would consider auto. Will...

I have a 2000 7.3 and I'm pretty sure its time to replace the glow plug relay. I located it on the truck and now I just have one question. There are two that look like a like. Is it the one closest to the firewall or the one closest to the grill/bumper? Thanks in advanced.

:Okay I'm new to the site so bear with me guys. I'm looking for a truck, I've always loved the mid to late 90s trucks and my dream truck is a 97 f250 psd extended cab with a 5 speed tranny. Unfortunately my funds have me set around 5000 to spend. But if anybody is trying to get rid of a truck...

97 F250 7.3 Ext. Cab Long Bed with Mods $10K Looking to sell my 97 F250 7.3 Extended Cab Long Bed 4x4 with some mods. Parts list includes: K&N Cold Air Intake Tony Wildman TS 6 Position on the fly chip Swapped D60 in front 3" Down Pipe into 5" Pipe, 6" Stacks, 1 Cat in system Built Trans by...

Hard to find these in Indiana. So I am broadening my search area. I understand these are hard to find, so I am willing to wait to get the one that is right for me. Thanks three one seven four zero three one eight nine three Dean

I was adjusting my ebrake and obviously adjusted it too far and the cable snapped so now I need to replace the front cable and the middle section. Is this an easy fix or kind of time.assuming and exactly how do i do it? I know its cheap only like $32 from autozone just never done one before. Thanks

I bought my first diesel in November. A 1996 F350 Powerstroke with 180,000 miles. I have been noticing an Oil leak from the drivers side and Im not sure where it is coming from. My first thoughts were head gasket or valve cover but Im not really sure. It seems to be just below the drivers side...

Hello everyone, I am currently looking for a work van for a part time business I run. I originally had been looking at 2005 E350 6.0 PSD's with around 100k miles, but after seeing so many complaints about them online I am not sure. More specifically, I wonder if this is an inherent problem...