Ford Powerstroke Diesel Forum banner

no crank

  1. 94-98 7.3 Motor Problems
    Appreciate any and all input. 1996 Ford F250 7.3L Ran in march, Father had the glow plugs replaced. Soon after it died and would not start. Cranking the truck, no smoke at all. Tach slightly moved above 0. One battery had some dead cells. Replaced that with a new one. I keep them charged...
  2. 6.0L Problems Forum
    This could get a little long, and I will update it as I have time. The truck is a 2003 F250 2wd. 180k on the odo. All new fluids and filters. Studded. egr and cat delete. New injectors. New oil cooler. New batteries. Tuned using an X4. Running Looney Wild tune for studded trucks. So, the other...
  3. 99-03 7.3L Powerstroke Problems
    I have a 2002 f250 7.3 psd. Yesterday after driving to the gas station, the truck would no crank no start, and still is. My ignition switch is ok. I think my small red wire that comes off the starter comes up into the engine bay, but mine isn’t attached to anything. I believe that’s my issue. It...
  4. 6.0 Motor problems
    Looking for a little help. I've looked at numerous threads but, haven't seen this exact problem. First of all I have a 2004 1/2 F-250 KR LWB 4WD. Model with the ICP on the valve cover. The truck has 158K on it now. Nothing but routine maintenance for the last 30K. I cranked it this morning...
  5. 94-98 7.3L Problem Forum
    97 F350 7.3L Diesel. No crank situation when I turn the key to "start". All dash lights, etc come on. I haven't been able to find the answer, so I apologize in advance if this has been answered before. Here's what I have figured out so far: All fuses check out. It is not the batteries. It...
  6. 99-03 7.3L Powerstroke Problems
    Ok so this is my first post on here. Well recently I get in like usual, turn the key, wait for the glow plugs to warm up and try to start it. But when I turn the key nothing happens. No clicks no nothing. It was doing this about almost every time I try to start it. Battery's are new and voltage...
  7. 99-03 7.3L Powerstroke Problems
    Hey y'all.. I have done my fair share of reading posts similar to problems I am having but haven't found anything exactly the same yet. Some background.. I have a 2000 CCSB F250 7.3L with 190k mi. Thursday morning I got off work and went out to my truck. It started like a champ. Drove 7 miles...
  8. 99-03 7.3 Motor Problems
    So I go to leave work today and the truck just clicks! It has a pretty much brand new starter solenoid that I tried to jump with a screwdriver with no success. Tried tapping the starter with a hammer.... no success but you can ever so slightly hear the starter trying to turn. Tried jumping the...
  9. 99-03 7.3L Powerstroke Problems
    Alright guys I need some quick help please. I have a 1999 F350 Powerstroke 4x4 with an ignition problem and I'm supposed to be headed home from college for Christmas break in a week - so I'm kind of stranded. I'll make this quick and to the point: Tried to start my truck and the ignition...
  10. 6.4L Problems Forum
    HI, Tonight my 08 F250 would not crank after I made a quick stop at NAPA. Relay on the fuse block clicks, but the starter will not crank. Disconnected the Brown w/green stripe wire next to the battery and jumped it to the battery and it starts up, so the starter is okay. Do any of you have any...
  11. 6.0 Trannie problems
    OK..so I am new to this forum and I hope I can get some advice and also pass on some recent learnings. I was headed across rural Ga in my 2004 Excursion when tow/haul light starts flashing and truck goes into limp mode. This is not too alarming as I have already experienced the dreaded...
  12. 6.0 Motor problems
    2004 x stock. The truck has had some issues. Under a load the truck seems to buck and blow black smoke and it seems to happen more after its hot and after fueling or after the truck has been turned off. Now, went out this morning and it will not crank. I can start it with jumping the solenoid...
  13. General 6.0L Discussion
    While the wife was driving her 2006 F250 down the road, the tow haul light started flashing, then the engine light came on. The wrench light, and abs light also came on. Then all the gauges quit working. When I checked for codes the only code that came up is a U0155. For loss of...
  14. 99-03 7.3L Powerstroke Problems
    Hi All, New to the forum. I have a 2000 F250 7.3 manual tranny that was put away for winter storage and now will not start. Need it to get my weekend work done now that the snow is finally gone. Symptoms: - not cranking - no dash lights (no oil light, battery light, etc.) - radio works - head...
  15. 6.0L Problems Forum
    My 2003 f250 6.0l 4wd is not cranking unless I jump the starter. Once running transmission feels stuck in 3rd. Tow/hual switch doesn't work and can not get it to engage in 4wd low. There are 9 codes. I will post those once I get home. But the list of disribtion as follows; #3 injector...
  16. 99-03 7.3 Motor Problems
    My early 99 F250 will crank and start once, but if I come back later in the day, it will either click-click-click, or not even crank. My batteries are charged, and connected cleanly (to my knowledge), but nothing will happen when I turn the key to ON, with engine off. sometimes the dash lights...
  17. Engine 911
    Hey fellas, another problem here! Anyone know if an 04 6.0 pcm can be rebuilt? I started out thinking that my fuel pump was bad ( no crank, no pump noise, no water in fuel light), read a post about unpluging the middle clip on the pcm and tried it. Well, it cranks now and i can hear the pump...
  18. General 6.0L Discussion
    Ok so one day I go to start my truck ('05 Auto 350 112k) and everything works normal except it wont crank. I messed around with the shifter and it started right up in nutral. So I am thinking it is a switch on the shifter but not sure where that might be. Anyone else have this problem? Thanks...
  19. 6.0L Problems Forum
    Have a 03 6.0 no crank, no reverse lights , no back up sensor stuck in 4 low electronic 4 wheel drive. Has new hpop, new ipr , new icp, pulled ficim and PCM and put them both in another 03 that one started and ran fine. Reinstalled in my truck and it fired right up and ran fine. Tightened every...
  20. General 6.0L Discussion
    Have a 03 6.0 no crank, no reverse lights , no back up sensor stuck in 4 low electronic 4 wheel drive. Has new hpop, new ipr , new icp, pulled ficim and PCM and put them both in another 03 that one started and ran fine. Reinstalled in my truck and it fired right up and ran fine. Tightened every...
Top