Ford Powerstroke Diesel Forum banner

ipr valve

  1. 6.0 Motor problems
    Looking for some ideas on this... When I installed my remote oil cooler, I planned on replacing the IPR valve screen while I was in there. I have always had fast starts and my engine is a 2007 reman that appears to have all of the update work. Just seemed the thing to do. I tried getting the...
  2. 6.0 Motor problems
    I have a 2004 ford f350 i did the egr delete on it and after it i started and it ran perfectly fine for a good 20 seconds then it shut off. but it will start right back up everytime. If i start it and rev it up to 1500-2000 RPM's it will stay running. i did the wiggle test and that did nothing...
  3. 6.0 Motor problems
    Hello everyone. I have a 2003 F350 DRW 6.0. The motor has had apr studs, egr delete, 4" straight, Oil cooler upgrade, FICM reprogrammed, and a few other minor tweaks. Today while I was heading to the airport my truck started slowly loosing power and stalling out. I pulled off to the side of the...
  4. 6.0L Problems Forum
    I have an '06 F250 with the usual mods: studded, egr delete, full Banks setup and a SCT Livewire TS. When I accelerate ( foot to the floor ) my ICP goes to about 800, the turbo spools to 20psi and the exhaust howls like a big dog but the truck doesn't seem to move quickly. When I accelerate...
  5. 6.0 Motor problems
    I have a 2005 6.0 and I've been reading up on the uphill leaks and the forums point to ICP sensors for 03-04 models but my ICP sensor on 2005 engines is on the front of the engine. Could it still leak and make it's way back to the oil drain plug area? Could it be the IPR valve leaking back...
Top