Ford Powerstroke Diesel Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 43 Results
  1. 6.0 Motor problems
    I noticed that I’m leaking diesel from or around my exhaust manifolds. I read this could be stuck injectors, but I’m not throwing any codes and there is no loss of power, and no mixing of any fluids or other signs of a blown head gasket. does anyone have any ideas on what it could be?
  2. 6.7 Problems Forum (2011-2016)
    I got a 2012 Ford F-250 that has swollen lug nuts on it. I can get them off but my problem lies turing hem back on because I’m not gonna be able to tighten them back down to the right spec. Considering I use this truck for towing it is vital for them not to fall off. So if i go the route to...
  3. 6.0L Performance Parts Discussion
    Edited: I have enjoyed the use of the SCT (I had said X3 in my original post, since learned because it has 3015 on the back it was the SF3) tuner since I bought the truck with the system already installed by the previous owner who also bulletproofed it. I was always satisfied with the default...
  4. 6.7 Exterior Discussion (2020+)
    I'm thinking of buying a new 2021 F-250 and am wondering about the durability of the aluminum body. I've only had steel body trucks. when I looked at them at the car lot it seems when you barely pressed on the body it would flex a lot easier than a steel body. To people that have them, how has...
  5. Introductions
    Hello From Okinawa Japan. I know my profile says Illinois, and technically that is correct. I am a US Marine stationed in Okinawa for the past two years, and im just counting down the days until i get home to my new truck. Recently purchased a 99 7.3L F-250 Lariat Supercab, the same as one of my...
  6. General 6.0L Discussion
    Hello, when i bought my truck (2005 F-250 4X4) both ABS sensors were bad, i didn't pay too much attention at the moment, but now i had to replace the front wheels bearing and bought the new sensors, my problem is that i can't find the harness on passenger side to connect the sensor, i remember...
  7. 99-03 7.3L General Discussion
    Rock Krawler Hauler Build - My 1999 CCSB 7.3 4wd - 188k miles This story begins in the summer of 2012 when my wife surprised me with a jeep for my birthday. We had just finished 25 long months of doing Dave Ramsey's debt snowball and paid of $60k in those 25 long months. So she wrote a check...
  8. 6.7 Problems Forum (2011-2016)
    Hello everyone, I currently am in the works of upgrading my full message center cluster to the LCD productivity cluster and having an issue. I have a 2011 F-250 6.7L XLT CC LB, and purchased a cluster online (DC3T-10849-JF) which came out of a 2013 F-250 6.7L King Ranch CC SB. Once I installed...
  9. WANTED
    Howdy all! I am currently seeking out a 2000-2002 7.3L 4WD XLT/Lariat supercab truck to take care of. Prefer lower than 100k miles. Closer to CA the better. Gray prefered (silver/white ok) Currently have a '99 XL with 300k, but everyone keeps running into me! :( Getting use to this site...
  10. Trucks
    2001 Ford F250 XLT CAB & 1/2 8FT LONG BED 7.3L Clean Title Automatic 218k miles Ice Cold Air Power Everything, Monster Mats, Trailer Brake Upgraded Newer Version Front Grill, Upgraded Newer Version HeadLights and Blinkers with Halo Fog Lights, Upgraded Newer Version Blinker Heated Power...
  11. Introductions
    Dropping a note to say hello. Here we have a 2003 F-250 7.3L 63K Miles. Ready to work.
  12. 6.7 Exterior Discussion (2011-2016)
    Hey... So I did some research and figured about the biggest tire I could run on a stock F-250 (leave me alone!!) would be a 295/65 r20 on the stock wheels. I ended up going with the metric size over the standard 35x12.50 r20 simply because of the capacity on a metric tire over a standard...
  13. 99-03 7.3L Performance Parts
    I have an early 1999 F250. It is a 6 speed manual 4x4. I have a TS 6 position chip. I cleaned the terminals on the PCM multiple times. There is still some tin left on the terminals though. When I install the chip, I observe the following: On Stock: The truck cranks and drives fine. There...
  14. Exterior Parts
    SOLD! I am selling take offs from my new 2015 f-250. They are in perfect condition. They had about 1000 miles when I took them off. Asking $250 OBO plus shipping.
  15. 94-98 7.3L Exterior Discussion
    Im looking to lift my 97 extended cab, long box about 3 or 4 inches. my front shocks need to be replaced so i figured what better time. This is my first lift so i was just looking for some info on what all i will need and anything to lookout for
  16. General Diesel Discussion
    Hey guys new the forum here. just wanting to get some insight about a 6.0 i'm looking at its a 2005 f-250 6.0 its has 128,542 miles on it . it has bigger injectors, head studded, egr delete, 4 inch straight pipe, 4 inch light with xd wheels and 33" all terrain tires. Questions. Its from a...
  17. Trucks
    PRETTY NEW TO THE FORUM, I HAVE BEEN COMING TO FIND ANSWER OF MY OWN BY READING OTHER PEOPLE'S THREADS BUT NEVER HAVE MADE ONE OF MY OWN. BUT ANYWHO I' AM LOOKING TO SELL MY 04" 4X4 F-250. THE TRUCK IS A 2 OWNER TRUCK THAT WAS ORIGINALLY PURCHASED IN YUMA, ARIZONA, AND HAS SPENT ITS WHOLE LIFE...
  18. 94-98 7.3L General Powerstroke Discussion
    Im considering mounting two PIAA LP570 on the front bumper, its the new LED light but looks like an old school halogen, id like to see some pictures of other 92-96s with trail light on the front bumper! Thanks Tom
  19. 99-03 7.3L Powerstroke Problems
    I was torquing my head back on, and when I was doing the last sequence, at 105 ft-lbs, a little tiny piece of the head broke off on one of the outer bolts. I was still able to get the head torqued down, but is this going to be a problem for me?
1-20 of 43 Results
Top