Ford Powerstroke Diesel Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 39 Results
  1. 94-98 7.3L Problem Forum
    Bought 97 f250 7.3 with the following 160cc injectors E fuel pump Adrenaline HPOP Has a adrenaline computer with a 6 pos tune 4 inch down pipes 6637 intake Riffraff boots ZF5 trans 4:10 axle On stock setting on tune I only make 1 psi boost going 60mph at 2000 rpm. EGT sits around 600-650. I...
    egt
  2. General 6.7 Discussion (2017-2019)
    hi guys. i have a 2017 powerstroke that i recently did a delete on. im running a mini maxx tuner right now. after reading all the forums, i hooked up the egt sensor that i took from the dpf i took out onto the blocker plate, and connected it to the connector the egr temp sensor was connected to...
  3. 6.7 Problems Forum (2011-2016)
    I drive my truck with 58K miles about once a week, longer trips 100 mi. + once in 2 months. Started up today, engine light on. Used Konnwei which says P246F. Anyone can confirm whether that's an EGT sensor out? Which one? Should I replace all 4 on this 2014? Thank in advance, all. Jerome...
  4. 6.7 Performance Parts Discussion (2020+)
    I'm waiting for my new 2022 6.7 F450 Cab & Chassis DRW This truck will only be used for heavy towing. I want to do a compound turbo. For the high pressure I want to replace the stock VGT with another VGT with much better quality, performance and HP rating. What would you recommend? (If it's...
  5. 6.7 Performance Parts Discussion (2020+)
    I'm waiting for my new 2022 6.7 F450 Cab & Chassis DRW I'll planing to do these upgrades: 4.88 gears, 2 stroker fuel pumps (w disaster prevention kit), lift pump, bigger radiator, bigger intercooler, cold air intake, coolant filter, engine oil bypass filter, engine & trans oil cooler with...
  6. 6.0L Performance Parts Discussion
    Just installed my SCT X4 on my 2003 ford excursion with a 6.0. Has headstuds, bulletproof egr cooler, and remanned heads. I am trying to get better mileage and whether that happens or not, would it be safe to run the canned performance tune on it? Keep in mind it has a stock exhaust. My main...
  7. 94-98 7.3 Motor Problems
    Hi all, I've got a 1997 F250 with the 7.3L Powerstroke that is experiencing high EGT's while towing my 24' enclosed race trailer, about 7k lbs when towing. I've been chasing this since I installed my gauges and seen just how crazy hot the EGT's are - easily at 1400* without a load. Here are the...
  8. 99-03 7.3L Powerstroke Problems
    I have exhausted all of my resources as far as asking programmers and researching multiple forums. I have a 2000 F-350 with the 7.3, crew cab, long bed, with the ZF-6 and 230,xxx miles. Full force Single shot 180cc/30% and New HPOP (stock), KC300x (63/73 and .84 housing), FRX, HPX, S&B intake...
  9. General 6.4L Discussion
    I have used this forum in the past to help with some 6.0 issues I was having. Unfortunately, I became very familiar with everything involved with the 6.0. Over the 10 years that I owned my f250 with the 6.0, I had my hands on everything from injectors, bullet proofing, HPOP, coolant filter...
  10. 6.0L Performance Parts Discussion
    Does anyone have info or some directions on what wires need to be spliced into the analog cable for iTSX? I have the innovative diesel EGT probe which connects to an adapter which has a firewire plug - however iTSX does not have that input connector so they provide their analog cable which needs...
  11. General 6.7 Discussion (2011-2016)
    Ok, so I'm having a little issue setting up my new phone (android) with Torque Pro to monitor some things on the 2015 SD diesel. Hope someone can help out. I got through the set up and pairing and all that good stuff. When I went to add displays, I added two of the EGT sensors and went for a...
  12. 6.0L Performance Parts Discussion
    My friend gave me an old Edge Evolution (EEF1200) monitor for my truck. I just plugged it in today and everything works great. I was wondering where I could buy the factory EGT probe that comes with it? (He didn't have it.) I have found ones for the newer CTS monitors but not the one I have...
  13. General 6.0L Discussion
    got a smoke switch on the truck yesterday. not for smoke , but just to give it more of a rumble at idle . so being im used to the 1.32 A/R on my "other" truck . I decide to play around with opening the turbo up at different RPM and throttle positions to get a feel for how the truck reacts...
  14. 99-03 7.3 Motor Problems
    Hello all. I have a question about pre and post EGT temps. I have stock turbo with a Banks compressor wheel. I have a pre turbo temp probe in rear of drivers side manifold and the post turbo right at the turbo outlet with a Banks Monster 4in turbo back exhaust NO Power Elbow. and still have...
  15. 99-03 7.3L Powerstroke Problems
    First, I searched for a solution to this before starting a new thread so if this turns out to be something simple I apologize. BACKGROUND The truck is a 2000 F-250 with a 6 speed and about 130k. It runs great for it's age and mileage, and by that I mean that the injectors are getting a little...
  16. 6.4 Motor Problems
    2008 6.4l SD XLT Crew cab with AFE air filter and Bully Dog GT tuner. In the last few months, I have been noticing my EGTs getting higher solo and towing my 7,000 lb trailer. I have towed the trailer for the life of the truck. This last trip towing, I reached 1,550 degrees. As soon as I back...
  17. 6.7 Performance Parts Discussion (2011-2016)
    OK, so I've got a 2011 F350 (SRW) 4WD longbed that I use to tow either a 20' rollback car trailer, a 26' enclosed car hauler or a 35' gooseneck 2 car wedge hauler. 60% of my usage is towing, 40% just daily driving. I'm currently at 70k miles and don't want to do anything that will void the Ford...
  18. 99-03 7.3L Performance Parts
    So I just ordered a stage one cooling mist kit. My question is where should I mount my injector? I would prefer not to put it on the spider because if I go to sell the truck, I may take it off and don't want to spend a lot to replace it. Any ideas? Can I put a tee in somewhere? Thanks a lot!
  19. 99-03 7.3L Performance Parts
    I got a chip with david lotts tuning. It is great, however, it runs hot as all hell. After a few seconds with my foot in it I have to let off because im hitting my 1250 egt warning light. I want to cool it down some. I know I can spend thousand or so on a turbo. Not in budget. Or spend a few...
  20. 99-03 7.3L General Discussion
    Before bringing my truck in to the shop last week, my EGTs were consistently at 650 when driving with cruise at 70. After getting my truck fixed, it now runs at 800-825 at 70 with cruise on. The truck is a 2001 Crew Cab 4x4 with a 4" lift, 35s, cold air intake, DP-Tuner F5 chip, and 5" straight...
1-20 of 39 Results
Top