egr valve

Throwing p0405 EGR sensor a circuit low EGR has wet soot gunking it up. Rolling coal like a sonofa and I’m not leaking coolant. I tried some Seafoam, didn’t work to well. but I realized this morning when it was cold it was driving fine but now it’s hot out and I’m smoking out everyone behind me.

My truck has had issues after it warmed up. When cold it ran fine, but after a while whenever you hit the gas it would hesitate a few seconds blowing a lot of black smoke. Then it would finally go and the smoke stops. As soon as I take my foot off the accelerator and repress it, the same...

So the recent 30 degree days here in Southern Alberta have forced my hand on plugging back in my EGR Valve. Since I have the latest flash it seems that the computer will reduce fan functionality and also reduce the functionality of the Turbo Veins. So yesterday I went and plugged in the EGR...

I have a 06 f350 with a 6.0l enough said rite but I am trying to get it running. I took it to the dealer with white smoke and slow at getting up to speed they said it was the egr cooler agian. So i had it towed home to do it my self I ordered a sinster egr cooler kit and i put in a new oil...

So my Scangauge occasionally showed that my EGR valve was at 100% (full open) for long periods of time, but when I've pulled the EGR valve it was closed but still giving a 100% reading. I noticed that if I unplug the EGR valve when it is reading correctly the reading instantly jumps to 100% so...

Check engine light, P0404 and P1335 codes. Bought the new EGR valve and am ready to replace it. I am planning to remove the whole elbow so I can clean that out while I am working on it. I understand getting the valve out of the elbow is a tough row to hoe, but I am more concerned about...

I have a 2006 6.0 F350 with approximately 200K miles on it. I put a Swamps FICM on it in 2011, 8 new injectors in March of 2013, a Bullet Proof EGR cooler and inner oil cooler in September of 2013 along with a new 4" turbo back exhaust. The truck has less than 5,000 miles on the injectors and...

Hey everyone, Read and searched, but I still cannot find a solid solution or an idea to what my problem is. I have a 2003 6.0L bone stock its a 6 speed. Picked the truck up last week. So far it has been pretty good.. Head gaskets are good, EGR system seems to be working fine. It has started in...

I have a 2005 F250 and it has been a great truck. We just hit 100,000 miles and it started jerking and blowing black smog every time it would jerk. it would do this for a bit but after continuing to drive it would stop and drive fine. (Probably not the smartest thing to do!:doh:) Now it dies...

I was having problems with after down shifting back down to around 2000 rpms it has a hard time getting past it and will black smoke a lot so i pulled the egr a cleaned it i did have to replace one of the O-rings and had to re-tap one of the holes that the bolt goes in the code for the EGR is...

I have a NEW IN BOX MotorCraft CX-2366 EGR Valve......asking $100.00 accept PayPal [email protected]

Ford recently replaced the egr valve & cooler a few months ago and I put a couple thousand miles on it and decided to go with the delete kit. Any questions or pictures let me know.

I thought I'd follow up on eagledieselmedic's excellent EGR valve write-up for those of us unfortunate souls who get to tinker on the van version of this engine. I definitely followed those directions, as well as some of the diagrams from Alldatadiy to do this job. For those expecting to...

just wanted to post a quick note. I have a 08 f250 6.4 i was throwing a egr dtc and was in limp mode. i took off the plastic sensor cover on the egr valve and found that the pins that connect the sensor to the electric motor that activates the egr valve had corrosion like a battery terminal in...

I have been having an issue with my '07 6.0L I was going up a hill last month, when suddenly my truck lost power, would not rev over 1200RPM and a large plum of black smoke came from the exhaust pipe. I had it towed home and plugged it into my tuner, got the code P0404, which is an EGR issue...

I have been having problems with my truck overheating. I think it is the egr cooler. Any suggestions. I have also seen oil coming out of the tailpipe. Don't want to drive but need to for work. Any help would be great.

i have been tossing around the idea of deleteing my EGR system ever since i bought my 6.4. also i noticed reciently that my coolant level drops occasionally, with a brand new radiatior, so i am assuming that it might be the egr cooler that is leaking?? is this a good enough excuse to delete the...

Whats up everyone i'm new to this. I have an 08 f-350 6.4L which had a banks air intake and a bully dog Programmer. The EGR valve went. Ford tells me its because of the banks air intake and that it lowers the EGTs so much that the fuel isn't being burned properly. Anyone else have this problem...

I know this must have been discussed here hundreds of times. I tried search feature but I still have no good answer. I own 2005 F350 Powerstroke. It's been losing coolant. The Ford dealer tells me that they will fix it for $4000!! They say, I need to replace the EGR valve, oil cooler and...