Search Results for ‘ebp’

From many people in this forum, I’ve learned several key differences between my 03 and 04 6.0 Powerstroke trucks. The inferred EBP (pcm calibration) that our 03 uses just seems to work better. No EBP tube/coupler/sensor to worry with cleaning as well as the resulting decrease in performance when...

I just cleaned my EBP sensor, tube, and coupling back in February. Haven’t towed a whole lot since then. Driven daily on mostly flat, open roads at 55+. Not a whole lot of idle time except on cold morning warmups (3-4 minutes tops). I’ve always used Archoil fuel additive… supposed to help with...

2006 6.0 not bulletproofed or tuned. Hello, I am having a problem with losing boost. I get at least a po299 low boost. I have also received a P0471. It happens after the truck gets up to temp. When codes cleared it boosts well in park and neutral until it warms up completely. I have searched...

Need some help with a few issues that may or may not be related * over-boost with low power condition, *lagging shift 5-6 gear(hangs out around 2000rpm too long, barely on throttle on flat road) *possibly too much EBP or a biased reading from MAP and EBP sensor , and corresponding VGT position...

Desperate for help! Have to go to work in the morning. New to the site. Hope I'm doing this right. I have a 2003 F250 6.0 PS 250K+ miles 2wd. Replaced all the injector o-rings the other day, and ever since it's had no power. Connected the ScanGauge II got 20+ lbs of boost but no EBP signal. The...

I have a weird issue here. Under light acceleration on flat ground I can have one of two things happen: 1)the turbo builds some boost and I can hear it definitively. Under light throttle pressure I will see around 8 psi 2)under the same throttle pressure, flat ground and speed I will have less...

Hey, fairly new to the diesel world. I've got an 06 that's almost all stock except for head studs, and egr delete. Recently the trucks engine light has come on and giving these codes. P0069, p0470, 71, 72 and 78. Except the MAP they all appear to have something to do with the EBP. Has the best...

Howdy everyone, I'm new here. I have been looking for some answers to why my truck is acting they way it is. To start I have an 04 f250, it had a ebp code and read 0 psi so I replaced the sensor and cleaned the tube. After I started it up the veins would not close down and still read 0 psi. My...

How do I remove the ebp sensor on my 2005 6.0 f350. It looks as if it has 2 nuts on the exhaust end. Is there a video or a detailed outline anywhere. Thanks.

Just bought a 2006 King Ranch with 71,000 miles. the truck has a K&N air filter system and a Edge Programmer. There are 3 issues I have with this truck and before I take it to mech i wanted to see if someone in here could ease my mind. Issue #1: My check engine light is on and the code is...

Hello, I've searched some but cant find an answer. This morning a was trying to track down the possible of highish egt (just installed pyro, so im not sure if the readins are high). Someone suggested that the EBP maybe gummed up and suggested comparing EBP, MAP, and Baro (truck sat overnight...