Search Results for ‘computer’

Hey everyone!!! So on the road in my 95 crew cab and I shut it down to order at a drive thru. It did not want to start again so I turned my hydra tuner to the bypass "00" mode and it started. Everything was cool till the end of day and I got to hotel. I went to reprogram my tunes from hydra back...

I have recently acquired a 1998 E350 with a 7.3. I'm planning on pulling this motor for a Bronco toy project. What are my must have parts, especially from a computer stand point, that I must have out of the van before I scrap it? All help is extremely welcomed.

I am dealing with a 2008 f550 with a 6.4. Had several leaks here and there, new hoses and radiator took care of that. Drives fine empty but with any load on it gets hot. Found water in oil replaced timing cover, water pump and thermostats. Ran down the road with my snap on scanner on it, and...

So I have stumbled across a 2003 F350 with a 7.3L that has everything I'm looking for in a new truck. However it does not run due to a bad computer, i have no other information other than that. The dealership has had it for over 3 years and because of the limited amount of 7.3's produced in 2003...

Hello. I have a 1999 f250 7.3 6 speed. I am having issues with my PCM diode located in the fuse box under the hood. Every four months or so the truck will begin surging while pressing on the gas pedal. Once this happens the diode will blow within a few days and require replacement before the...

After 3 years, 10k, two motors, I'm at my wits end, and frustrated to death with the lack of knowledge at the Ford dealership. Here's whats happening; It starts fine in the morning, if I let it idle it cuts out within 5 to 10 minutes, and won't restart. If I jump on the freeway, it runs...

03 6.0 with egr delete. I just put new reman heads on my truck. I've put it all back together...again. The first time, I had the dealer flash my truck to newest strategy and found out quickly that the cooling fan was disabled. I hooked an egr valve in and cooling problems significantly...

When i was installing my new ts performance chip i unhooked the batteries but didn't tie the terminal back and it made contact as i was installing the chip now i think i fried my ecu :doh: my ecu code is apx1 1c3f 12a650-yb and i cant find a ecu is there other ecu's that would work in my truck...