Ford Powerstroke Diesel Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-10 of 10 Results
  1. 6.7 Motor Problems (2017-2019)
    “Def fault”came up on the dash and check engine light came on. Exhaust fluid is full and was full. Code is saying knock sensor. Open the hood and oil seems to be coming from hot side to inner cool . Anyone have a problem like this? Thanks!
  2. 6.7 Performance Parts Discussion (2011-2016)
    The cold side pipe finally burst on my 2011. While replacing it with an H&S kit I noticed all the soot&oil buildup on the butterfly. Just exploring, I pulled the butterfly off to clean it and the intake inner diameter was probably a half inch smaller from all the soot/oil buildup! I wish I took...
    ccv
  3. General 6.7 Discussion (2011-2016)
    Hey gang. I broke one of the little tiny slide-locking tabs on an electrical connector on the engine harness. I'm pretty sure the same slide lock is used on several electrical connectors, for instance when I replaced my hub/bearing assembly I think the ABS wire connector had the same little...
  4. 6.0 Motor problems
    Hey guys I'm back. And I know how we love our videos. Do you think this is normal smoke (oil vapors) from my CCV or could this be Exhaust Blow By??? http://youtu.be/k9HD0xNvJvM It smokes like this hot or cold, fresh start or ran for hours, and does not seem to increase when I step on the...
  5. General 6.4L Discussion
    Ok so I put on my No-Limit intake a couple weeks ago. I did the ccv mod at the same time as the intake doesn't have a port for it. When the conditions are right I have a what would appear to be a cloud coming from under my truck. ( not much actually comes out of it, but it looks like it.) there...
    ccv
  6. 6.4L Performance Parts Discussion
    I thought I would make a build thread even though I dont have much done yet compared to some of yall but will add to it as I go on. Hopefully I can help answer any questions and share what problems I ran into. Dont have the best pictures yet cause I had to dig through old pictures to make this...
  7. 94-98 7.3L Performance Parts
    I'm doing injectors and noticed my ccv pipe looks like it was cut. I bought the truck used, and im not sure what the purpose of this is for, buy its definatly not factory. The pipe probably has two inches with a bend going up and is flat, with cut marks. It practically buts up against the intake...
  8. 99-03 7.3 Motor Problems
    I have an 01 Excursion and I'm fairly new to the diesel scene. Just some info on the truck; it has a TS performance 6 gun switch, custom CAI, 4' straight pipe, Banks down pipe and waste gait eliminator, 4:56 gears, Custom drive shaft, CCV vent mod, to name a few. The problem I'm having is that...
  9. General 6.4L Discussion
    Well, i finally found time to do the ccv mod, It took me about 20mins and 20$'s. I didnt take any pics while I was doing it but, if anyone is interested I can take a pic and post them just let me know. P.S: there is quite abit of smoke that comes out of it you cant see it unless you crawl under...
  10. General 6.4L Discussion
    i just saw something about a crankcase vent modification on a 6.4. is this something that i should do? if so where do i find a kit or how do i make one, havent found much info on this. any info helpful
1-10 of 10 Results
Top