Ford Powerstroke Diesel Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-14 of 14 Results
  1. 6.7 Problems Forum (2017-2019)
    I was using the exhaust brake coming down a 10% grade (without towing) and it was working fine. Suddenly it just stopped working ( wasn't a noise or anything else I noticed) it just stopped working and so I manually geared down. I tried to use the manual and automatic exhaust brakes after that...
  2. 6.0 Trannie problems
    Well, it's been a while since I have had to post post a question here but alas, here goes. My Excusrsion (2003 6.0) has thrown a P0730 and P2703 code. It goes into reverse abnormally hard and has a shudder in reverse. When I go to drive it start in 1st gear and shift through the gears into OD...
  3. 6.0L Powerstroke Interior Discussion
    My driver side glove box (BOX-UTILITY LESS-HOUSING) as they call it at ford broke a while ago. Im pretty sure I just need the latch. Does anyone know where I can get a new latch or even a replacement box? Looking at this everyday is driving me crazy!
  4. 99-03 7.3L General Discussion
    ok so when I pulled out my engine, my cherry picker wasn't high enough, so I had to improvise. Well I got it out, but managed to crack a box in the mean time. My question is, what is it and should I replace it? Thanks! And my improvision...:rofl:
  5. 99-03 7.3L General Discussion
    Nobody is responding to me in the problems thread, so please someone help. I am trying to get my engine back together and above the cam I found what appears to be a broken something or other. is this normal??
  6. 99-03 7.3 Drivetrain Problems
    Hi, I have a 2002 f250 crewcab with a 4" Rough Country lift and 315/75/16's on it, 360000kms. Before I lifted it the cardan joint was stuffed so I had a new one put together and reinstalled it when the lift was put in. Is there anything I should have to do to accommodate the lift as far as the...
  7. Suspension & Steering
    Hey guys I'm decently new to this forum, id appreciate any help I can get. I have a 2000 F250 SD 7.3L, Ext Cab Short Bed. bought it used about 5 months ago with 248k. I've got just about 260k on it now. Long story short passenger needle bearing went got the rubble strip rumble, two days of...
  8. 99-03 7.3 Motor Problems
    No one in the obs forum is responding, and I know a few of you guys will know... I ran across a deal, its a 97 7.3 that needs a turbo and hpop. He says his uncle had it hooked to a snap on scanner and there is no oil pressure coming from the pump. He also says the turbo is shot the air filter...
  9. 99-03 7.3 Motor Problems
    I ordered a replacement oil dipstick tube, as the top 6 inches off of my old one. :doh: Something to do with replacing the UVCH on the passenger side :D so if I replace it, will the dipstick simply slide out of the flange? or do I need to loosen the flange or anything? Thanks guys!
  10. 99-03 7.3L General Discussion
    Hello fellow powerstrokers. I was changing my oil the other night and I'm not sure if this fell out of my pan. It may have been in my drain pan and I just did not see it. Anyway, I was wondering if anyone may know what this is and did it come off my truck..I drive a 2002 F350 7.3 with 209,000 on...
  11. 6.4 Motor Problems
    I have no compression Cylinder 8 and Ford tells me I need a new block which I don't understand they could possibly know without disassembling. My warranty is up and they quoted me 22k for a new block. It sounded like a lost jack hammer in my motor when it happened. Anyone have any ideas comments...
  12. 6.4 Exterior Discussion
    im not sure if i got a faulty shock or they cant take a beating but i purchased these 3 weeks ago and one already broke/bent and the shock fluid went everywhere and got on everything. any one else have this problem?
  13. 6.4 Drivetrain Problems
    my 4x4 will not enage at all????? any suggestions
  14. 94-98 7.3L Problem Forum
    hello everybody im new here. i have a 1995 f250 4x4 stroker. i have tried shifting the truck into 4x4 recently and the transfer case just wont engage. the truck is a 5 speed and manual transfer case with shifter on the floor. any help would be appreciated thanks
1-14 of 14 Results