Search Results for ‘ball joint’

Hey guys, I appreciate you dropping in and offering any advise possible. Here's a brief timeline of the truck: 7/2014 - Purchased 2014 6.7L F250 Lariat FX4 CCSB. 1/9/2015 - Installed no name 2.5” spacer leveling kit. (33k miles) 2/3/2018 - Installed 35x12.5x20 Toyo AT2s. (75k miles) 8/2018 -...

HI, I'm new to the forum but not to the 6.0. I have a 2005 4x4 that I bought new and I must like it! Here is my problem: I needed to replace the front axle u-joints so I figured I would install new ball joints, axle seals( the new one), hubs, rotors and calipers. Everything was going well, afer...

My wife and I are planning a cross country camping trip this summer and I have begun gathering parts for certain weak parts on my truck among them is the front end steering and suspension. I am not a mechanically intuitive guy and will be having a local shop install the parts however the parts...

Hello all, Is there such thing as a leveling kit that doesn't destroy your front end angles? Here in the communist state of Massachusetts we can't have lifts so unfortunately that's out of the question. My last truck (2006 F150) I ran a level and was going through hubs every 15-30k and don't...

Well I just got done doing ball joints on my F250 & of course the f350 decided, while I was at it, to start making a clicking/bumping noise so it needed new ones as well ! so I am getting pretty good a them. Not a bad job really, hell the hardest part was figuring out how to set up the Advance...

Hi, my names Curtis and im new to the forum.. I have a 2006 f-250 4x4 king ranch, and lately when I start speeding up from a stop i hear what sounds like a pop and it does it when i come to a stop. Today I got under my truck to drain the oil and noticed this red dust on the bottom on my front...

I just recently noticed that when looking at my truck from the outside, the passenger side of the truck sits noticeably higher. I measured it out and it sits about 2 inches higher on the passenger side. I also noticed that the tire sticks out a little bit on the passenger side while the drivers...

First, it's good to be back. Been building my shop and other things the last year or so. All right, it's about time to start rebuilding the front end. The death wobble went from non-existent to horrible in less than a month's time. I mean it literally was not there unless I purposely induced...

So most of the big threads, write-ups and videos on the Superduty Ball Joints seem to be 1999 - 2004 model year specific. Since front axle was upgraded to a Dana Super 60 in 2005 there are going to be different parts lists for the 2 year ranges. Aftermarket Ball Joints are the...

Does anyone know where i can find low profile 90 degree grease zerks for the upper ball joints on my 02 F-350 Crew cab. I just replaced all of the front end components and was told there are some low profile zerks out there but they didn't know where to find them.