Search Results for ‘7.3 1996’

Looking for help with troubleshooting. Ford 1996 F350 7.3 Intermittently the overdrive light will began to flash and the truck will go into limp mode but will clear itself out after a few minutes normally. ABS light and brake light are on the dash. The speedometer will also bounce around a good...

96 f250. Replaced fuel filter and filter cap( motorcraft filter with a riffraff aluminum cap) Replaced fuel selector valve drove 2 miles and truck ran out of fuel. Same issue I had before put hoses back to front tank only and got it to start again idled for about 30 min with no issues 15 min at...

1996 f250 7.3 diesel replaced my ipr, idled fine for 4 seconds then loped/surged terrible and check engine light popped on. Wouldn’t stop Got another new ipr and installed found threads messed up on hpop, replaced hpop and installed ipr (assuming it just threaded in at random). Truck took...

For some context this all started when I was driving the truck and it felt like it was missing on a cylinder. It then resolved itself temporarily. I took the truck for a spin around the block the next day. It was missing again and under throttle white smoke came out the exhaust. This ended with...

hey Ya'll I have a 1996 f-250 with the 7.3 power stroke. this truck was sitting for 12+ years so I know there are going to be issues, but the truck was passed down so any money going into isn't bad! things that have been FIXED 1.starter 2.X2 value cover gaskets 3.starter solenoid 4. both...

Just got a 96 F-250 7.3L. Got a problem with it and I’m not sure what it is. There is hardly any soot coming out of the exhaust except for only hard pulls on the interstate. While I’m on the interstate sustaining 70-75mph I can feel the engine bay getting very hot and can feel it at my feet and...

I have a 7.3 obs and it doesn’t get too cold where I live (30-40 degrees) and when I cold start (only waiting for the wait to start light to turn out not fully waiting for the glow plugs) a lot of white smoke comes out of the back of my engine bay/ hood. I can’t put my finger on what it smells...

I have a 96 F250 7.3 and i was looking into the block heater. When i bought it i was told it didn’t work. I plugged it in for about ten minutes and realized no lights or anything were working. I checked the battery voltage and it dropped all the way to 1.5V. Last night i took the clamps off...

Ok guys hear me out, I’m going to paint this picture. Buddy has a 1996 f250 7.3 short bed 265k miles, rebuilt about 20k. Absolute cleanest truck I’ve ever seen inside and out. He has babied it an taken care of ALL maintenance. No tranny issues, last big drive was from California-Utah with no...

I have a 96 F250 Super cab long bed with no mods and the mechanical fuel pump. A month ago the truck died and I ran a hose from the suction side of the pump to a can of diesel and got it started but it was pissing out of the weep hole in the fuel pump. So I replaced the pump with a Carter pump...

Got OBDLINK LX, and its the first tool to even attempt to read but i ended up with a laundry list of codes and was wondering what this could mean. Crank no start condition, harness was fried in a handful of spots, 2 GP wires were fried, GP and Starter solenoid dead, icp presumably dead(oil in...

Morning, 1994 F250, XLT, 7.3L PS, Manual, 4x4 has a motor from a 96 medium duty truck with 2100hrs on it now Recently I bought this truck, first diesel, and it needed a little TLC. Rough idle, low fuel pressure, and leaking fuel bowl. So I threw on the following in hopes of fixing this and...

Hey guys. This is my first post. I have a low mileage mint 1996 f-250 7.3. It’s in very very good shape. All original. And I have every document in a folder for every service ever done. And original window sticker. Truck has no mods. Like I said all original. I’d like to sell it to buy a piece...

So I’ve had a problem I can’t figure out. My 96 7.3 is slow cranking like batteries are dead. I’ve had them tested separately and both are good. Installed new starter, solenoid, glow plus, and glow plug relay. Replaced terminals with new ones and it’s still slow cranking with no start. The volts...

this is my first post and I figured I’d post this bc I have no clue what’s wrong. I recently blew the turbo on my ‘96 7.3. It’s a stock Garrett. I bought a rebuild kit from KC Turbos and I installed it. When I turned the truck on, it was idling rough, but not too rough with white smoke coming...

I'm looking at a 1996 and a 2000 7.3, and I'm specifically concerned about buying something that is too difficult for me to work on myself. I have a '96 F250 gasser that is a PITA to work on. Was that a '96 thing? The body style on the 7.3 is different from my gasser, so maybe it's not bad to...

Hey, so my truck has been shutting off randomly for a few weeks and seems to get worse when it rains. The wait to start light comes on and it restarts on its own, or it will stumble for a second or 2 and then shut off and I can restart it and it’ll run fine. Which seems weird. I’ve also noticed...

New user here, thanks in advance for any help/guidance... I bought my 96 f250 7.3 a couple months ago. It was hard starting when I got it. I bought an ob2 mx scanner and ran a buzz test using forscanLite. Injector #4 was bad. Also had some bad connections on the valve cover gasket harness. I...

I have a 1996 F250 with 184xxx miles on it and I just recently checked the transmission fluid in her and it smelled like crayons. Should I change it or what should I do. Because I have heard about people changing theres and it mess something up. Please let me know as quick as you can. Thanks, Chan

keep getting the same code when using scanner on truck. P605 how would I go about repairing this? P1211 replaced icp already and its still throwing the code P1705 wth is this. Something about not being in park or neutral. Then im also getting a code for the exhaust back pressure sensor. I...