Ford Powerstroke Diesel Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 9 Results
  1. General 6.0L Discussion
    I have a 2006 6.0 powerstroke with 176k miles. Bought it about a year ago and shortly after I had an injector go out. Put new warren diesel 190/30 injectors in it and got some custom tuning. Here recently I’ve been having a fuel problem, or what I believe is a fuel problem. Every time I go past...
  2. 6.0 Motor problems
    Getting the code P0272 injector 4 contribution/balance failure. There is a new injector wire harness put on, new fuel pump because of blowing bubbles in the upper fuel filter. The truck starts but wont idle for more then a few minutes. I have AE and i put the idle set higher to 750 and it...
  3. 6.0L Problems Forum
    Has anybody had any experience with an injector going bad after a short period of time? I had just installed 8 Warren Premium 155/30’s and the truck ran perfectly fine for about 50 miles, and the truck suddenly started running like crap. Brought it home, truck had a cylinder #3 contribution...
  4. General 6.0L Discussion
    I just did injectors on my 2004 6.0 power stroke and when I unplug cylinder #1 it doesn’t change my idle. Trying to figure out if harness or ficm or no contribution. Can’t hook up scanner being Obd2 port won’t work. It gets power once scanner goes on then loses power.
  5. 6.0 Motor problems
    I have a 2003 f250 with 197k miles. I bought the truck over the summer and it had a very minor fluctuation in the idle (enough that my diesel mechanic buddy did not consider it an issue). As the temperatures dropped the "rough" idle has become more prominent. The truck starts fine and pretty...
  6. 6.0 Motor problems
    so while idiling last week it started loping out of no where when i hooked my ae scanner up it came back with injector 1 circuit code so yesterday i replaced injector 1 truck ran great for the most part then this morning while driving to work it started falling on its face and would idle up to...
  7. 6.0 Motor problems
    I have an 06 f-250 with an H&S, EGR delete, HPOP, rebuilt turbo, and 5in. the truck runs and starts fine untill you drive in for more then an half an hour or so. At which point the truck starts violently shaking. and when you let off the throttle to stop or pull over the RPM's drop to around 400...
  8. Introductions
    Welp, my name's Mike, obviously. I rebuild 6.0L diesel injectors for a living. I started at my job when I was 18, I'm currently 19. I've been through every process of rebuilding them from breakdown to testing. I'm very picky about my job and I do it VERY well. You got a question related to a...
1-8 of 9 Results
Top