Ford Powerstroke Diesel Forum - Search Results
Advanced Search
Showing results 1 to 25 of 380
Search took 0.03 seconds.
Search: Posts Made By: Calkidd
Forum: General 6.0L Discussion   07-14-2019, 07:56 PM
Replies: 8
Views: 378
Posted By Calkidd
I like his tow map the best. I get lower EGT's...

I like his tow map the best. I get lower EGT's and it gives just a touch of extra HP over stock.
Forum: General 6.0L Discussion   06-19-2019, 08:02 AM
Replies: 5
Views: 212
Posted By Calkidd
This post is a little confusing. "No start...

This post is a little confusing. "No start condition" what do you mean? Have you tested the voltage while your cranking the motor? When you say high 20's is this while it's cranking or after the...
Forum: General 6.0L Discussion   06-19-2019, 07:57 AM
Replies: 8
Views: 378
Posted By Calkidd
What tow tune are you using? And yes you still...

What tow tune are you using? And yes you still want to activate the tow/haul button. I have Eric's tow tune and haul a 38' toyhauler.
Forum: 6.0L Electronics Discussion   06-19-2019, 07:50 AM
Replies: 4
Views: 275
Posted By Calkidd
I wanted to give an update to this post just in...

I wanted to give an update to this post just in case there are others that have read this and might be scratching their heads. Even though I usually go back through and check what I did different I...
Forum: 6.0L Electronics Discussion   06-16-2019, 04:59 PM
Replies: 4
Views: 275
Posted By Calkidd
Found the problem....The DC Power Alt was over...

Found the problem....The DC Power Alt was over charging. After the dash would stop working I tested the output voltage and it was 16 - 17 volts.

I hope the blue wire mod didn't cause this to...
Forum: 6.0L Electronics Discussion   06-16-2019, 02:59 PM
Replies: 4
Views: 275
Posted By Calkidd
DEAD dash after blue wire mod...PLEASE HELP

I did the blue wire mod for my fan clutch. I used the upfitter pass through wires to gain access to the inside of the cab (the truck does not have upfitter switches). After doing this mod the dash...
Forum: 6.0L Performance Parts Discussion   10-28-2018, 07:29 PM
Replies: 12
Views: 4,656
Posted By Calkidd
If you look at the comments in his Youtube video...

If you look at the comments in his Youtube video he and I had a short conversation. In short he got screwed by Turbo Labs of America. It was poor quality and faulty parts. TLoA completely quit...
Forum: 6.0L Performance Parts Discussion   10-17-2018, 07:26 PM
Replies: 6
Views: 6,175
Posted By Calkidd
I am sure since the most recent post of this...

I am sure since the most recent post of this thread was 6 years ago; I can assume things have changed along with customer service.
Forum: 6.0L Performance Parts Discussion   11-05-2017, 07:59 PM
Replies: 19
Views: 2,155
Posted By Calkidd
I have been extremely happy with Matt and the...

I have been extremely happy with Matt and the SRL+ tune. Granted the tune is is probably 7 years old; the truck runs great. I would have to say Matt has been around the longest. Back when I got his...
Forum: General 6.0L Discussion   11-12-2015, 01:33 AM
Replies: 36
Views: 3,171
Posted By Calkidd
I have been looking at these lately with many...

I have been looking at these lately with many good reviews.

LED Lights - LED Headlights - GTR Lighting (http://www.gtrlighting.com/led-headlights/)
Forum: General 6.0L Discussion   11-11-2015, 07:48 PM
Replies: 36
Views: 3,171
Posted By Calkidd
That was my question. If the two are not similar...

That was my question. If the two are not similar even better.
Forum: General 6.0L Discussion   11-11-2015, 06:58 PM
Replies: 36
Views: 3,171
Posted By Calkidd
If LED's are like HID's in a reflector housing...

If LED's are like HID's in a reflector housing then I am out. Nothing is more asinine when HID's are install in a reflector housing without the use of a projector lens. It's dangerous and...
Forum: General 6.0L Discussion   11-06-2015, 10:30 AM
Replies: 10
Views: 2,553
Posted By Calkidd
Mine was doing something similar you what you are...

Mine was doing something similar you what you are describing. I had it cleaned and the problem went away. I was also getting a hesitation while under a load similar to the feel of it missing in a...
Forum: General 6.0L Discussion   11-06-2015, 01:59 AM
Replies: 9
Views: 2,032
Posted By Calkidd
A statement like that is misleading. To run the...

A statement like that is misleading. To run the engine that high while under acceleration is dangerous and you're beating the **** out of the motor. But during deccel its not as hard on the motor,...
Forum: General 6.0L Discussion   11-06-2015, 01:31 AM
Replies: 5
Views: 600
Posted By Calkidd
I forwarded you a PM I got regarding DIY traction...

I forwarded you a PM I got regarding DIY traction bars.
Forum: General 6.0L Discussion   11-06-2015, 01:24 AM
Replies: 10
Views: 2,553
Posted By Calkidd
Unison ring and/or vanes are sticking.

Unison ring and/or vanes are sticking.
Forum: 6.0L Exterior Discussion   11-04-2015, 11:57 PM
Replies: 11
Views: 1,172
Posted By Calkidd
I have purchased the Hawk severe duty towing...

I have purchased the Hawk severe duty towing pads. I will have to say I was not impressed. The pads have no initial bite and you have to wait until the pads heat up before you have any type of...
Forum: 6.0 Motor problems   03-16-2015, 11:03 PM
Replies: 6
Views: 718
Posted By Calkidd
Thanks for the reply. I am not sure if I am...

Thanks for the reply. I am not sure if I am deciphering the diagram correctly.

Going back to the ground. I was looking at the ground from the battery and it seems to be 0000 cable. It's about 1"...
Forum: 6.0 Motor problems   03-16-2015, 07:48 PM
Replies: 6
Views: 718
Posted By Calkidd
Bueller...Bueller...

Bueller...Bueller...
Forum: 6.0 Motor problems   03-15-2015, 09:45 PM
Replies: 6
Views: 718
Posted By Calkidd
DC Power Altenator Malfunction or am I crazy?

This might have been covered here on PS.org, but I was unable to find a similar situation. Sorry for the lengthy post, but hopefully this might shed some light on others that have experiences...
Forum: General 6.0L Discussion   10-28-2014, 02:34 PM
Replies: 11
Views: 1,247
Posted By Calkidd
Regardless of how "easy" you are on your truck...

Regardless of how "easy" you are on your truck what you have to be careful of is the chamber pressure. Just because you are light on the throttle doesn't mean the chamber pressure isn't way up there.
Forum: General 6.0L Discussion   01-08-2014, 02:31 PM
Replies: 11
Views: 1,166
Posted By Calkidd
You might want to check out The Retrofit Source...

You might want to check out The Retrofit Source online: headlight upgrades for all applications (http://www.theretrofitsource.com). They have the necessary kit to install a "true" HID projection kit.
Forum: 6.0L Performance Parts Discussion   01-08-2014, 02:08 PM
Replies: 16
Views: 2,185
Posted By Calkidd
Have tried both Eric's and Matt's (Gearhead) and...

Have tried both Eric's and Matt's (Gearhead) and I personally like Matt's SRL+. I found my truck responded to Eric's as more a light switch response which made it more difficult for everyday...
Forum: General 6.0L Discussion   03-20-2013, 02:37 PM
Replies: 5
Views: 881
Posted By Calkidd
Being that your ECT is low, I wouldn't put too...

Being that your ECT is low, I wouldn't put too much faith in the delta you're getting until your fix your low ECT. What i am saying is that your low ECT could be giving you false delta range.
...
Forum: General 6.0L Discussion   03-20-2013, 02:31 PM
Replies: 9
Views: 877
Posted By Calkidd
I would have to say MTS has done one of the...

I would have to say MTS has done one of the better write ups on this. I concur HID's in a halogen reflector is no bueno.
Showing results 1 to 25 of 380

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome