Ford Powerstroke Diesel Forum banner

Boost pressure guage on

1K views 4 replies 4 participants last post by  HVAC SuperTech 
#1 ·
whats up guys. I just started installing my three guage pillar from diesel manor and I was wondering where you guys were installing the fitting for the boost guage. Any help/pics would be great.
thanks fellas
 
#2 ·
well, alot of people delete their AIH, or air intake heater. Its on the left side of the Y pipe comming off the turbo(if your looking into the engine bay from the front.)

They get a fitting to fit that thread size and put a compression fitting in there and tie it in. Or, you can just T into the map line, and go from there. I didnt have an AIH, so i went the T fitting route.
 
#3 ·
Those are great tips if you have a 7.3 Nick.. This is a 6.4 though:bump::bump: for the 6.4 guys
 
#5 ·
OOOPS! Sorry. I need to look up at which section I am in! Sorry!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top