Ford Powerstroke Diesel Forum - View Profile: bismic

bismic bismic is offline

Compression Ignition Addict

  Visitor Messages

Showing Visitor Messages 1 to 10 of 18
  1. mytruckbroke
    01-21-2020 04:51 PM - permalink
    mytruckbroke
    I running through this group of broke trucks around and found a new interesting one. cheap and look good. The guy said he lost compression on #8 it is on zero after changing hpop. he suspect dropped something in the engine while intake off. zero would require a hole in a piston or stuck open valve. is there anything else that might cause this problem you can think of? thanks
  2. jjohnsonlta
    11-23-2019 08:10 AM - permalink
    jjohnsonlta
    Thanks. Turns out I have one of those I was not using. I seem to remember that it was so long it hit my leg. I have sense bought a extension cord but never used it with this one. I will get this hooked up in place of current one. Thanks again.
  3. jjohnsonlta
    11-23-2019 05:08 AM - permalink
    jjohnsonlta
    I saw in a recent post of yours that you recommended a certain elm for using with torque app. I can't seem to find the post. I would like to get a better one than I am using now. With mine sometimes it only reads half of my pids I am monitoring. It will also lose communication with the app for periods while driving. Which one did you like?
  4. chatvmax
    10-03-2019 05:39 PM - permalink
    chatvmax
    Hey ,
    built that dash as u specified
    [email protected]
    - 724-797-7784 - I'm a texter also -
    noticed tonight during a hard starting " event " on like my 5 long crank I was up to like 162 rpms and still no start,,
  5. NCFX4
    08-27-2018 01:32 PM - permalink
    NCFX4
    Hey, bismic. I didnít want to hijack the thread so I want to ask about your 6.0 a/c comment. You say theyíre pretty reliable but I want to pursue that. I have an Ď04 6.0 CC SWB Lariat and over the past 15 months have had the compressor and clutch fan replaced along with some minor bits like o rings, etc. My wife is recovering right now so I have no time to get under the hood myself and also have no a/c experience. So far the dealer costs run around 3 grand. My biggest issue still exists and thatís very poor performance at idle and sometimes even slow running. On normal my vents are pushing 52-54 degree air. Jump ahead to a test I did...a 24 inch biig *** shop fan in front of the condenser at full speed and the air on max gives me 38 degrees at the vents. Obviously I canít do this on the road but Iím looking at a pusher fan in addition to the stock setup.
  6. NCFX4
    08-27-2018 01:28 PM - permalink
    NCFX4
    Hey, bismic. I’m trying to send a PM about your a/c comment and I’m having issues. I’m at
    [email protected]
    Could you give me a shout if you get this? Thanks...Ed
  7. Sbexportinc
    06-11-2018 07:11 PM - permalink
    Sbexportinc
    Hi, can you tell me how to know or test a fuel pump is good or bad
  8. MakoWish
    04-30-2018 04:46 PM - permalink
    MakoWish
    Hi Bismic,

    I saw this post:

    https://www.powerstroke.org/forum/gen...your-help.html

    And I was wondering if you still have that spreadsheet available. I realize that is an old post, but I would be interested in obtaining a copy if possible. There should be no issue sending 10MB to this address, but try [email protected] first, and see if that works.

    Thank you, sir!
  9. peixinho
    01-17-2018 10:07 PM - permalink
    peixinho
    We recommend pre lubing the turbo. It is also a good idea to jump the starter wire near the passenger battery, that will also help prelube the turbo.
  10. Patriot
    03-19-2017 07:41 PM - permalink
    Patriot
    I tried to say you're welcome in PM but your PM inbox is full and won't accept any more.

  About Me

  • About bismic
    State/Province
    Texas
    Ride
    2006 6.0L PSD FX4
    Engine
    6.0 factory turbocharged
    Cab Configuration
    Crew Cab Short Box
    Drivetrain
    Single Rear Wheel 4X4
    Tranny type
    Torqshift
    Tires
    Street Radials
    Horsepower
    0.0
    1/8 Mile ET
    0.000
    1/8 Mile MPH
    0.00
    1/4 Mile ET
    0.000
    1/4 Mile MPH
    0.00
  • Signature
    Mark
    06 F250CC SB FX4 Lariat; ARP studs; OEM gaskets; Banks exhaust; DynaTrac Ball joints; RACCCV6000; JimmiJammers; Ravelco; SynchroMax in trans case; Fumoto valves; Harpooned; Blue regulator spring; DashDAQ; PHP FICM; RiffRaff boots; DCPower 270AXP; Power Inverter; Bilstein shocks; BPD EGR cooler, radiator, water pump; SCT w/ SRL+; Rotella ELC Ultra Coolant; X2Power AGM batteries
    No-start thread:
    https://www.powerstroke.org/forum/ge...-no-start.html

  Statistics

Total Posts
Visitor Messages
Total Thanks
General Information
  • Last Activity: Today 04:32 PM
  • Join Date: 04-05-2007
  • Referrals: 3

  Friends

Showing Friends 1 to 3 of 3
  • buf4rd22
    • buf4rd22 is offline
  • King Henry
    • King Henry is offline
  • kingranch2006
    • kingranch2006 is offline

  Mentions

02-23-2020
04:22 PM - SH2006 mentioned bismic in post IPR 85% No Start, No codes....out of ideas
bismic Currently around 50...
04:04 PM - SH2006 mentioned bismic in post IPR 85% No Start, No codes....out of ideas
bismic 7.28 ms after a few ...
02-21-2020
06:26 AM - Joshua Billman mentioned bismic in post Number 6 contribution balance code with no explanation
bismic do you know if the p...
02-20-2020
03:20 AM - bismic mentioned fordsvtparts in post CM5126 Screen Kit OEM Part Number?
...very active here - fordsvtparts
02-19-2020
07:57 AM - jokester00 mentioned bismic in post 2005 F250 Witing Harness Question
...connector?? Hydro bismic nighthawk285 The t...
02-17-2020
07:58 AM - Hydro mentioned bismic in post A Doozy Of A Crank No Start Challenge For You All!
... a loose connection bismic any opinions?
02-13-2020
07:01 PM - bismic mentioned Strato_54 in post more issues have risen
... happens tomorrow. Strato_54 - Status update? Di...
02-10-2020
07:53 AM - Hydro mentioned bismic in post Truck Died No Crank No Comm with PCM
...the connectors that bismic mentioned would be a...
02-06-2020
07:51 AM - jokester00 mentioned bismic in post 85% vgt at idle ok?
... the EBP value. bismic is right - my CTS2 r...
02-04-2020
12:15 PM - ChrisSki mentioned bismic in post HFCM
... the junk out that bismic mentioned in the HFC...
02-03-2020
01:41 PM - beetzaf mentioned bismic in post Beetz Heck Outta Me
Thank you Hydro , bismic and john galt for th...
01-30-2020
04:59 PM - jokester00 mentioned bismic in post Im Stumped... HELP!!!
Agree with bismic - you've got some so...
01-28-2020
06:42 AM - ChrisSki mentioned bismic in post Crank no start
...ut it going again. bismic talked about adding ...
01-27-2020
10:33 PM - bismic mentioned Discount Tire in post 6.0 Chat Thread
Good job Discount Tire. I was wondering ...
05:44 PM - jokester00 mentioned bismic in post Which head is from the driver side and which one is passenger? 05
Hydro bismic G8orFord -joke...
01-20-2020
07:47 PM - JRo_6.Slow mentioned bismic in post Cranking, but no start
...rmonic balancer? bismic Iíll check, i talked...
01-19-2020
03:07 PM - Hydro mentioned bismic in post Diesel shut off going down the road
...a running system bismic, there are 6 codes l...
01-03-2020
06:31 AM - G8orFord mentioned bismic in post Torque pro missing intermittent gauges
...ut the BAFX (Thanks bismic) but I've never trie...
01-01-2020
04:05 PM - Hydro mentioned bismic in post High Pressure Oil
...engine for years bismic, glad you keep a pre...
12-30-2019
10:25 AM - jokester00 mentioned bismic in post '06 no start appear to have ICP, ficm V/sync
Agree with bismic about replacing batt...

  Quotes

02-22-2020
05:48 PM - nubrun quoted bismic in post 2003 6.0 Intermittent Overheating
When the coolant temp went ...
07:47 AM - bismic quoted Built06F250 in post Hot no start
There could be numerous issues. ...
02-21-2020
07:00 AM - Joshua Billman quoted bismic in post '06 no start appear to have ICP, ficm V/sync
...are good. Thank you bismic and hydro. You've be...
02-20-2020
04:39 PM - fordsvtparts quoted bismic in post Parts request
Never mind - you answered t...
02-17-2020
06:41 PM - Hydro quoted bismic in post 2003 6.0 Intermittent Overheating
...it is possible for it to...
06:40 PM - bismic quoted 16ecas in post hpop leak
the old pump had the same h...
01:28 PM - nubrun quoted bismic in post 2003 6.0 Intermittent Overheating
I am. Hard to say for sure...
12:59 PM - nubrun quoted bismic in post 2003 6.0 Intermittent Overheating
I don't think the clutch is...
02-16-2020
04:30 PM - Rkelley0726 quoted bismic in post Thick white smoke, surging idle, dying, hot no start, and "knock"
Fuel is miscible with oil. ...
08:34 AM - twood71 quoted bismic in post Diesel shut off going down the road
Glad you got it runnin' goo...
07:10 AM - 05.6blow quoted bismic in post 85% vgt at idle ok?
The EBP sensor places an im...
02-15-2020
06:45 AM - bismic quoted SparkyF250 in post 6.0 Chat Thread
PSN sucks BAD For your viewing...
03:52 AM - bismic quoted Strato_54 in post more issues have risen
i do strongly appreciate the a...
02-14-2020
10:44 PM - Strato_54 quoted bismic in post more issues have risen
Strato_54 - Status update?...
10:58 AM - bismic quoted 2005silverbullet in post Its cold and im doing something wrong...
I went over that list very helpful th...
02-13-2020
07:08 PM - bismic quoted Hydro in post 1,3,5,7 "New" Injectors Dead
...des? Like you said Hydro - I wish we had numb...
07:00 PM - bismic quoted Strato_54 in post more issues have risen
... happens tomorrow. Strato_54 - Status update? Di...
02-12-2020
08:55 PM - Strato_54 quoted bismic in post more issues have risen
I wonder how the mechanic c...
02-11-2020
08:57 AM - Fibonacci11 quoted bismic in post GLOW PLUG CHANGE LEADS TO HARD HOT START
...ools! Understood Bismic, Do you recommend Fo...
07:35 AM - Fibonacci11 quoted bismic in post Bad hpop?
...ant to look into it bismic, I need all the help...

  Feedback Score

iTrader Profile Recent Ratings
Feedback Score:
Positive Feedback:
0
0%
Members who left positive:
Members who left negative:
0
0
Total positive feedback: 0
Submit Feedback
  Past
Month
Past
6 Months
Past
12 Months
Positive Positive 0 0 0
Neutral Neutral 0 0 0
Negative Negative 0 0 0
 
For the best viewing experience please update your browser to Google Chrome