Ford Powerstroke Diesel Forum - View Profile: bismic

bismic bismic is offline

Compression Ignition Addict

  Visitor Messages

Showing Visitor Messages 1 to 10 of 14
  1. NCFX4
    08-27-2018 12:32 PM - permalink
    NCFX4
    Hey, bismic. I didnít want to hijack the thread so I want to ask about your 6.0 a/c comment. You say theyíre pretty reliable but I want to pursue that. I have an Ď04 6.0 CC SWB Lariat and over the past 15 months have had the compressor and clutch fan replaced along with some minor bits like o rings, etc. My wife is recovering right now so I have no time to get under the hood myself and also have no a/c experience. So far the dealer costs run around 3 grand. My biggest issue still exists and thatís very poor performance at idle and sometimes even slow running. On normal my vents are pushing 52-54 degree air. Jump ahead to a test I did...a 24 inch biig *** shop fan in front of the condenser at full speed and the air on max gives me 38 degrees at the vents. Obviously I canít do this on the road but Iím looking at a pusher fan in addition to the stock setup.
  2. NCFX4
    08-27-2018 12:28 PM - permalink
    NCFX4
    Hey, bismic. I’m trying to send a PM about your a/c comment and I’m having issues. I’m at
    [email protected]hoo.com
    Could you give me a shout if you get this? Thanks...Ed
  3. Sbexportinc
    06-11-2018 06:11 PM - permalink
    Sbexportinc
    Hi, can you tell me how to know or test a fuel pump is good or bad
  4. MakoWish
    04-30-2018 03:46 PM - permalink
    MakoWish
    Hi Bismic,

    I saw this post:

    https://www.powerstroke.org/forum/gen...your-help.html

    And I was wondering if you still have that spreadsheet available. I realize that is an old post, but I would be interested in obtaining a copy if possible. There should be no issue sending 10MB to this address, but try [email protected] first, and see if that works.

    Thank you, sir!
  5. peixinho
    01-17-2018 09:07 PM - permalink
    peixinho
    We recommend pre lubing the turbo. It is also a good idea to jump the starter wire near the passenger battery, that will also help prelube the turbo.
  6. Patriot
    03-19-2017 06:41 PM - permalink
    Patriot
    I tried to say you're welcome in PM but your PM inbox is full and won't accept any more.
  7. Patriot
    02-17-2017 07:40 PM - permalink
    Patriot
    I started on this site when you were a frequent poster. I've learned more from you than all these guys put together.
  8. chorbaa92
    01-14-2014 06:17 PM - permalink
    chorbaa92
    Soon to be 6.0 owner... Still have them spreadsheets everyone's talking about? [email protected]
  9. bucky1963
    03-19-2012 07:28 AM - permalink
    bucky1963
    Truck started and ran for a few seconds 3-4 times and now I have no start and no pressure on the icp any suggestions would be greatly appreciated.
  10. 05 Pstroker
    02-09-2012 08:20 AM - permalink
    05 Pstroker
    I have driven trucks for 32 yrs., including half ton , 3/4 ton and 1 ton, and have yet to get over 42K out of them. What tires did you get 85K out of them? If you don't mind me asking. Thanks, Tracy.

  About Me

  • About bismic
    State/Province
    Texas
    Ride
    2006 6.0L PSD FX4
    Engine
    6.0 factory turbocharged
    Cab Configuration
    Crew Cab Short Box
    Drivetrain
    Single Rear Wheel 4X4
    Tranny type
    Torqshift
    Tires
    Street Radials
    Horsepower
    0.0
    1/8 Mile ET
    0.000
    1/8 Mile MPH
    0.00
    1/4 Mile ET
    0.000
    1/4 Mile MPH
    0.00

  Statistics

Total Posts
Visitor Messages
Total Thanks
General Information
  • Last Activity: Today 06:33 PM
  • Join Date: 04-05-2007
  • Referrals: 3

  Friends

Showing Friends 1 to 2 of 2
  • buf4rd22
    • buf4rd22 is offline
  • kingranch2006
    • kingranch2006 is offline

  Mentions

11-11-2018
07:47 PM - Hydro mentioned bismic in post New diesel owner!
...n't the cups. As bismic said not likely the ...
11-02-2018
08:45 AM - jokester00 mentioned bismic in post oil cooler temp question
...L!! :laugh: Like bismic said, Your delta che...
10-05-2018
07:05 AM - jokester00 mentioned bismic in post Temperatures
... cooler plugged? bismic hit on a lot of them...
09-28-2018
05:24 AM - bismic mentioned fordsvtparts in post Advice for a diesel beginner?
...also. Mike fordsvtparts works for them and i...
05:19 AM - bismic mentioned SVT in post Advice for a diesel beginner?
.... Mike fordsvtparts works for them ...
09-26-2018
06:25 AM - LoxDiesel mentioned bismic in post Advice for a diesel beginner?
bismic has it handled [emoj...
09-12-2018
04:37 PM - Sock Puppet mentioned bismic in post New (to me) '05 F350 Looking for Advice
Looks like bismic beat me too it.
03:32 AM - Chris mentioned bismic in post Can't get top FUEL FILTER cap off
...l filter caps. Like bismic said, get the correc...
09-07-2018
10:05 PM - bismic mentioned G8orFord in post Someone please help (bad oil leak)
..., which (as G8orFord posted) is likely to...
12:05 AM - bismic mentioned john galt in post Fuel Pressure
...ng a max limit as john galt recommended ...........
09-06-2018
06:35 PM - ChrisSki mentioned bismic in post Someone please help (bad oil leak)
That kit bismic mentioned is a good ...
07-27-2018
05:14 AM - djmaguire mentioned bismic in post I'm newwwww, IDK what to doooo
I like bismic 's subtlety. I like...
07-11-2018
06:13 AM - G8orFord mentioned bismic in post 2004.5 6.0 Intermittent Rough Idle
...e-2.html Perhaps bismic wouldn't mind postin...
06-03-2018
01:55 PM - djmaguire mentioned bismic in post EGR Dummy Valve Now, Delete Later?
Yes to bismic 's comment. A weak ...
05-07-2018
12:20 PM - Heavy_GD mentioned bismic in post Question for @Mark Kovalsky
bismic .......
04-22-2018
04:58 PM - djmaguire mentioned bismic in post 6.0 Chat Thread
bismic brings up a good poi...
02:43 PM - G8orFord mentioned bismic in post 6.0 Chat Thread
...you going again. bismic toren302 LoxDiesel d...
04-17-2018
03:33 AM - bismic mentioned djmaguire in post Mishimoto Oil Cooler?
... - pun intended. djmaguire - where did you get ...
04-08-2018
04:36 PM - bismic mentioned fordsvtparts in post Need Help: Part Identification 2003 6.0
... that is needed fordsvtparts - can you verify thi...
04-07-2018
04:56 AM - bismic mentioned fordsvtparts in post Need Help: Part Identification 2003 6.0
...lug-w302297 Maybe fordsvtparts can help - or you ca...

  Quotes

09-06-2019
12:27 PM - bismic quoted RKadair in post P0284 Code 2006 F350 6.0 Diesel 100K miles
ficm repair.com sells on ama...
11:15 AM - bismic quoted ed2hess in post P0284 Code 2006 F350 6.0 Diesel 100K miles
I pumped out the fuel tank. ...
11:14 AM - bismic quoted ed2hess in post P0284 Code 2006 F350 6.0 Diesel 100K miles
The FICM have to be programm...
09-05-2019
06:05 AM - bismic quoted ncfirefighter140 in post 6.0 Chat Thread
Question, 06 F250. When after engine ...
09-02-2019
09:40 AM - 4x4ff quoted bismic in post Preventative HFCM replacement
Just remember there are man...
06:41 AM - jlang95 quoted bismic in post Crazy Smoke and Oil Out of the Exhaust
Sounds like you have narrow...
06:00 AM - jlang95 quoted bismic in post Crazy Smoke and Oil Out of the Exhaust
As I posted on PSN I would...
04:48 AM - bismic quoted 4x4ff in post Preventative HFCM replacement
I have 175k on mine and no...
09-01-2019
11:32 AM - jokester00 quoted bismic in post Preventative HFCM replacement
If you don't have a fuel pr...
01:06 AM - 5.9and6.0 quoted bismic in post 6.0 Chat Thread
Try 97*F w/ 90% humidity!!!...
08-31-2019
03:51 PM - AudioEng03 quoted bismic in post Check engine light? If oil cooler is bad
There actually is a code fo...
08-30-2019
03:31 AM - bismic quoted doubleslottedflaps in post Rebuilding injectors
I musta got a good 6.0. 190,000 on ori...
08-28-2019
06:54 PM - MrTackett quoted bismic in post Man, the smoke
I wouldn't count on the rot...
08-27-2019
03:25 AM - bismic quoted crankn101 in post Radiator change:What tranny fluid?
So my tranny pan has a drain p...
08-25-2019
06:31 PM - Gaius quoted bismic in post Man, the smoke
...sands in a way that bismic described. D...
04:44 PM - bismic quoted Gaius in post Man, the smoke
I wouldn't worry about the...
08-23-2019
12:31 PM - bismic quoted Wllys55 in post Idle question
Hello all, new to site and m...
08-19-2019
07:32 AM - DAV!D quoted bismic in post 05 engine runs no throttle (sometimes) also misses some times
...atalk What about bismic's post on the orient...
07:20 AM - DAV!D quoted bismic in post 05 engine runs no throttle (sometimes) also misses some times
There is a GPCM orientation...
08-18-2019
07:52 AM - twood71 quoted bismic in post At home tranny flush?
Best transmission flush pro...

  Feedback Score

iTrader Profile Recent Ratings
Feedback Score:
Positive Feedback:
0
0%
Members who left positive:
Members who left negative:
0
0
Total positive feedback: 0
Submit Feedback
  Past
Month
Past
6 Months
Past
12 Months
Positive Positive 0 0 0
Neutral Neutral 0 0 0
Negative Negative 0 0 0
 
For the best viewing experience please update your browser to Google Chrome