bismic bismic is offline
Compression Ignition Addict
- About bismic
- 2006 6.0L PSD FX4
- 6.0 factory turbocharged
- Cab Configuration
- Crew Cab Short Box
- Single Rear Wheel 4X4
- Tranny type
- Street Radials
- 1/8 Mile ET
- 1/8 Mile MPH
- 1/4 Mile ET
- 1/4 Mile MPH
- Total Messages: 15
- Most Recent Message: 10-03-2019 04:39 PM
- Visitor Messages for bismic
- Last Activity: Yesterday 05:30 PM
- Join Date: 04-05-2007
- Referrals: 3
|05:00 PM - Hydro mentioned bismic in post Another Cold Start Saga
...e ya go, looks like bismic nailed that one g...
|10:42 AM - zsargent mentioned bismic in post P0261 after alternator and batteries changed.
...oing to send you. bismic is right on.
|05:01 AM - zsargent mentioned bismic in post P0261 after alternator and batteries changed.
...ernators. I'm with bismic on that one as far a...
|07:28 AM - zsargent mentioned bismic in post P0299 fault
...ons/opinions here. bismic, kaya, Toren.....
|08:36 AM - jokester00 mentioned bismic in post To coolant flush or not to coolant flush that's the question
Again...as bismic asked, what were you...
|07:24 PM - Hydro mentioned bismic in post Replacing starters yearly
...s problematic As bismic stated about his mil...
|05:55 PM - Hydro mentioned bismic in post someone keep me from pushing my 6.0 off a cliff
...teering column As bismic mentioned, all three...
|02:06 PM - Patriot mentioned bismic in post Turbo heating up
...xDiesel, djmaguire, bismic, or any of the other...
|06:40 AM - jokester00 mentioned bismic in post Radiator change:What tranny fluid?
... this, but i'm with bismic and use Mercon SP. ...
|05:43 PM - zsargent mentioned bismic in post Man, the smoke
...sands in a way that bismic described. To the ...
|05:08 AM - SparkyF250 mentioned bismic in post At home tranny flush?
...e the one posted by bismic better. Never though...
|07:56 PM - Sock Puppet mentioned bismic in post Should I Install These Injectors?
...ncern. ZMANN Hydro bismic G8orFord I see the d...
|03:26 PM - Hydro mentioned bismic in post Contribution balance please help
...you have done what bismic said -- if there is ...
|07:36 AM - bismic mentioned PowerSmoke07 in post Stock 6.0 looking for advice on what mods to make
... 5000-7500 miles PowerSmoke07 - By your interval m...
|01:46 AM - Jjorgis5569 mentioned bismic in post Kind of new (to me) 6.0 & Upgrades
As bismic told me when I first...
|02:29 AM - Jjorgis5569 mentioned bismic in post Buying a used 2005 F250 - Have the known issues been addressed?
...he degas tank. Like bismic stated, itís overfil...
|11:02 AM - ChrisSki mentioned bismic in post First time power stroke buyer
...those miles, like bismic said, I would expect...
|08:22 PM - djmaguire mentioned bismic in post 6.0 Chat Thread
...here, too, IIRC. bismic prolly knows more th...
|07:22 AM - bismic mentioned koe in post Intermittent hot start issue question
...pical is 0.19-.24v) KOEO, no pressure regist...
|10:22 AM - SparkyF250 mentioned bismic in post Coolant Change updates?
...pg Finally like bismic said above since you...
|03:51 PM - crankn101 quoted bismic in post Hard starting when its below 20...
Multiple glow plug codes : ...
|02:48 PM - Mike Schmidt quoted bismic in post Interesting 03' 6.0 Issue, Help! PO278
Since you don't have much m...
|04:06 AM - Mikewmma quoted bismic in post Truck dies anytime I try to go past 40
Just checked map 100.50 bar...
|12:46 AM - bismic quoted Mikewmma in post Truck dies anytime I try to go past 40
Just checked map 100.50 baro ...
|06:11 PM - bismic quoted 0360powerstroke in post Powerstroke loss of power fixed!
Bismic never had a light pop on the ...
|04:47 PM - Mikewmma quoted bismic in post Truck dies anytime I try to go past 40
100kpa is fine for atmosphe...
|12:50 PM - Mikewmma quoted bismic in post Truck dies anytime I try to go past 40
Jokester posted that you ne...
|11:58 AM - Mikewmma quoted bismic in post Truck dies anytime I try to go past 40
great post jokester00 - I h...
|11:56 AM - Mikewmma quoted bismic in post Truck dies anytime I try to go past 40
Pressure at all times on th...
|07:40 AM - Mikewmma quoted bismic in post Truck dies anytime I try to go past 40
I think your other thread w...
|05:29 PM - fordsvtparts quoted bismic in post Positive battery cable ... BACK ORDERED !?!?
fordsvtparts may be able to...
|05:46 AM - bismic quoted zsargent in post P0261 after alternator and batteries changed.
You can test the FICM PM m...
|07:55 AM - Billthekid352 quoted bismic in post Start and stall
I would lean towards it bei...
|12:27 AM - bismic quoted Hoosierdually in post Another Cold Start Saga
Thanks for all the comments so far...
|12:44 PM - bismic quoted jokester00 in post Blown inercooler seal
18psi is all you see at WOT? Wh...
|05:16 PM - nickpo quoted bismic in post 2006 intake chug
Might consider putting an o...
|05:09 PM - bismic quoted Hydro in post Tired HPOP
You certainly could have v...
|02:10 PM - bismic quoted Flamed99 in post 6.0 Chat Thread
Scan gauge doesnt mean anythi...
|05:37 AM - Sonoma6Leaker quoted bismic in post Tired HPOP?
Remember - you need more th...
|04:12 AM - SparkyF250 quoted bismic in post 6.0 Chat Thread
I am sure it isn't your fir...
|iTrader Profile||Recent Ratings|