2001 brake controller wiring

[flatout26]

I just got a 01 PSD and it has an older brake contoller on it. I want to put one in it that I had in another truck. I'm not sure where the wires go that are on the plug under the dash. I didn't get any paperwork with the old controller. Does any have a diagram for the factory plug under the dash?
Thanks,
Ken

[bigcountrysg]

it should be an easy hook up. As the wires plug into the harness. That is under the dash you can see it if you lay on the floor board.

[sea71]

Your factory wires under thedash should have a plug(female) on the end of it. Kinda hard to get to, but it should be there. If it is, then you should be able to get a harness from the dealership that plugs into it, and then those wires are labled.

[flatout26]

My controller doesn't have a factory plug on it. I'll splice it into the harness that is hooked to the old controller. That's why I need to know which wire is which. ie: +12v, brake controller, stop lite switch, ground.
Thanks,
Ken

[bigcountrysg]

Originally Posted by flatout26

My controller doesn't have a factory plug on it. I'll splice it into the harness that is hooked to the old controller. That's why I need to know which wire is which. ie: +12v, brake controller, stop lite switch, ground.
Thanks,
Ken

3 wires, red 12volt hot, blue brake power lead, white ground.

[sea71]

You have a private message

[flatout26]

Originally Posted by sea71

You have a private message

Are you still up?

[Rufus]

If all else fails, go to the web site of the controler manufactor, they should have a diagram.

[Blue01F250]

here is where they plug into the truck - the brown harness plug going into the grey factory harness (if you have the controller harness - otherwise will have to cut/splice wires)

[flatout26]

Thanks all for the input. I think I got it worked out.
Ken