Ford Powerstroke Diesel Forum banner

putting in valve body, broke stud

742 views 3 replies 2 participants last post by  bigcountrysg 
#1 ·
when torquing down the valve body one of the two studs broke, the ones that the bolts go on, any suggestions??? help. call me asap at 952-836-8281 thanks
 
#2 ·
Remove the valve body. If there is some of the broken stud sticking out of the hole. Try to remove it with visegrips. Then you will have to replace the stud.
 
#4 ·
Heck you should be able to get a new stud anywhere. Just remove the other stud. Then go to a hardware store and match it up with a new one.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top