Tennessee Powerstrokes Logo

[trbo dsl]

You can give feed back here...

[trbo dsl]

The state is carbon fiber, the pistons are real (JE Forged H-beam rods)
font is "haunted" from dafont.com with yellow glow effects. Basically thinking of making an oval for the sticker to be cut out in, take a final look at the spacing of everything, font size, etc. then call it a day.

this was done with photoshop, with all the bells and whistles. (on a 2 terra byte hard drive!!!) yikes!

[GoFastPadre]

Looks good. What size are you thinking? I was thinking about a 6" by 8" The oval cut out would be fine with ne too. I would rather see no blue at the top behind the name, pistons and stacks. I suppose that is not part of the design though.

[Howard]

looks good to me too.

[crew991]

Hell Ya looks good

[GoFastPadre]

Originally Posted by trbo dsl

You can give feed back here...

I have sent out an e-mail to everyone I have addresses for, so we should see more replies soon.

[trbo dsl]

I measured my 01 and John's (the printer) 08. We both have a single sliding rear window that measured 13.5" wide.

I was thinking of about 12.5" X 7" (ballpark). Much smaller than that and you wont be able to read the text. I am thinking of wraping the text around the perimeter of the oval also.

[HVAC SuperTech]

I like it. Def gotta get rid of the red and blue. It looks fuzzy with it that small. Will it sharpen up with sizing it up?

[trbo dsl]

yes it will sharpen up. It looks great at actual size.

[chvyrkr]

Looks pretty BA to me! It's obviously gonna sharpen up right? And I'm good with either size, I'd prefer smaller, but whatever it needs to be for the text to stand out.