Ford Powerstroke Diesel Forum banner

Help! Need injectors for 6.0!

269 views 6 replies 5 participants last post by  Get Some 
#1 ·
So I went and got my truck looked at today, and it turns out I'm going to need new injectors. Since they're a little pricey, I have an SCT SF3 programmer that I am willing to trade for some injectors or sell for some extra cash. I know, priorities :doh:
 
#2 ·
I have a set all 8, but I know one of them has a problem others ran fine.
 
#5 ·
Yes they should be all the same if anything they might just need to be calibrated.
 
#6 ·
No they are NOT the same

Later model injectors have a DLC coating to reduce stiction. They will all work, but should be installed in sets of 8. You should not need to do any recalibration, unless you change FICM. Good Luck, I have a set of 2003 injectors with 4x,xxx miles, and a set of 2006 injectors with under 20k miles. Make sure you use new O-rings and copper washers or you will kick yourself in the ***.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top