Ford Powerstroke Diesel Forum banner

Pinion seal change problem

753 views 2 replies 2 participants last post by  zeuss 
#1 ·
I just changed ujoints and midshift bearing. I also am changing pinion seal. I took nut off but can't persuade the yoke to come off. Any write ups on changing seal and reinstall of yoke or any help would help. Truck is down and I need it. Thanks
 
#2 ·
yoke should pop right out. have you tried a little nudge with a bar? make sure you get it torqued back on right, your bearings will thank you, and so will your pocket book.
 
#3 ·
Evry other pinion seal I have changed I can just beat the pinion off and then just trun the nut back down and don't keep cranking on it and I am done. I can't even get the yoke off this one.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top