Ford Powerstroke Diesel Forum banner

SCT Gurus

1K views 7 replies 5 participants last post by  chomme 
#1 ·
Alright all you SCT pros...is there any way to use the SCT to determine what file has been uploaded to the ECM?

As an example, you flash the ECM with a program and then a year later want to change it to something, however, you forget what you had in there to begin with. Is there a way to check? Now I know this is an extreme case, however, I want to verify what program is in my ECM and am curious if there is a way to do that.

I know that I was able to check the strategy of my factory ECM, but now want to check what program is installed.

Thanks in advance!
 
#8 ·
I have pondered this same idea before. One of these days I'm going to attach our network security sniffer between my serial port on my programmer and the cable...it will be interesting to see what data got downloaded with the stock program, and look at what went back on, and see changes. Granted, it'll all be numbers and the such, but it will be interesting to see.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top