Ford Powerstroke Diesel Forum banner

Loosing clutch pedal, 00' 6 speed

2K views 10 replies 7 participants last post by  Cj Ford 
#1 ·
The past couple of days the clutch pedal has been getting worse. earlier today it was going to about 1/2 inche from floor before it will let me shift into get, and by tonight I have to shut the truck off to get it into reverse. Its not to the point I have totally lost it, where I cant get it out of gear, or be able to stop but I fear its on its way there. The clutch systems seems pretty simple, it just bothers me its all plastic. Is there any ideas, air in the system?the res is full. How would you bleed it?
 
#2 ·
I have been told easiest to bleed it on the bench but if you need a new one i have a spare i can send for a reasonable price.
 
#4 ·
New master cylinder from NAPA was 59.00 going to replace and bleed per instructions and see if that solves it. :thumb:
 
#5 ·
does anyone know where to get a good aftermarket clutch? one for the 450hp range?
 
#9 ·
:woot::woot::woot: for the Southbend!!!

Got mine from Patrick at Discount Power Parts. CONFE is the ONLY way to go....(Unless you have a TON of $$$....then get the twin disk!!!)
 
#10 ·
thanks guys
 
#11 ·
I went with the OFE and it works fine... no slippage at all Peter at sbc actually said it was the better clutch for all the heavy towing I do
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top