Ford Powerstroke Diesel Forum banner

Question about PIAA 520 lamps installation 07 PS

851 views 2 replies 2 participants last post by  2-2-go 
#1 ·
Your opinions please. The 520 PIAA lamps are controled by a relay with a second current source for the lamps which draw 14+/- amps. This is more amperage than I want to add to the high beam circuit. It would appear acceptable to control the relay with a high beam tap and the lamps with one of the 30 amp upfitter switches allowing the 520's to be turned off when not necessary. The 520 relay switch would be eliminated. Any imput is appreciated.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top