BigDf250

Truck is a 96 7.3l Turbo DI PS with about 280k miles on it. I drove the truck home with no problems. The next day it would not crank. The wait to start light would not come on and the rpm would not register. I changed the cam sensor (didn't help). Fuse #22 (PCM and fuel bowl heater) was bad and I replaced it. Now the wait to start light comes on and the tach registers while cranking. But it still will not start. Can anyone give me some clues as to what to check next. I am not a mechanic, so make your answers simple. I can work on it if I know what to do.

Truck is a 96 7.3l Turbo DI PS with about 280k miles on it. I drove the truck home. It ran fine. The next day it would not start. The engine turns over but it will not fire. I changed the camshaft position sensor and that didn't rectify the situation...The fuse #22 (PCM and fuel bowl heater) was bad and I replaced it. It is still checking out good. The tach does register a few RPMS while cranking the engine. This was after I changes the cam sensor. I was not before then. Can anyone give me some good clues?

Thanks