I was wondering, I have a small oil leak, Its most likely the back of the oil pan. Its very minor But i was looking around and noticed theres a pipe plug in the block on driver side. There are 3 of them. I believe one of them is the plug you remove to see what rods you have. Theres a real small one like 1/8 inch thread. That small one was not tight. I went to back it out to use a sealant on the threads but poil started leaking. SO I just tightened it. I am thinking maybe oil was barely getting out under pressure when the motor was running.
Are there similar plugs on the pass side of the block? These would have to be just behind the starter next to the back of the block? I dont want to pull the starter to look for a plug if theres none there. The 2nd bolt up from the bottom of the bell housing had oil on it. This is about an inch behind the small oil galley plug on drivers side. The other side is similar.
thx
Are there similar plugs on the pass side of the block? These would have to be just behind the starter next to the back of the block? I dont want to pull the starter to look for a plug if theres none there. The 2nd bolt up from the bottom of the bell housing had oil on it. This is about an inch behind the small oil galley plug on drivers side. The other side is similar.
thx